Flyer AC805 Folha de instruções - Página 2

Procurar online ou descarregar pdf Folha de instruções para Racks & Stands Flyer AC805. Flyer AC805 2 páginas. Front rack

Connect the Headlight to the Rack

A. Unscrew the nut and screw holding the headlight, reflector, and bracket together. Reverse the orientation of the bracket so

that it angels upward. Reassemble the headlight and reflector together by retightening the nut and screw into place.

B. Slide a lock washer on to the same screw that mounted the headlight to the bike frame. Next, slide a washer onto the screw.

Using the Allen key, screw the headlight assembly to the front of the rack. Tighten to 3Nm.

C. Ensure the headlight faces outward, angled slightly down while the reflector is vertical.

Remove the Front Plate

Unscrew the 4 screws from the front plate. This is where the

Front Rack will assemble.

Note: You will not re-assemble the front plate or the screws

to the eBike. We recommend maintaining the front plate and

hardware should you wish to remove the Flyer Front Rack in

the future.

Attach the Front Rack

Slide a M5 lock washer onto each of the provided 15mm

screws. Next, slide a M5 washer onto each of the screws.

Attach the front rack plate to the bike, by tightening each

15mm screw by hand. Fully tighten each screw to 3Nm using

the provided Allen key.

Reconnect the Headlight

A. Connect the extension wire to the headlight. Connect the other end of the wire to the original connecting port in the bike's head tube.

B. Secure the wire to the bottom of the rack frame using the provided zip ties. Secure the zip ties on the two wire brackets located on

Test the Wire Connection

To test the headlight wire connection, reinstall the

battery and turn the headlight on by pressing and

holding the "+" button. If not powering on, remove

the headlight connection and check for debris. If the

headlight still does not work after reconnecting, please

contact the Radio Flyer Customer Service team by email

1-800-621-7613.

Ensure there is enough slack in the wire, so the headlight does not accidentally disconnect while riding. The connector should be

inserted in the headlight so that the correct terminal shapes line up.

the bottom of the rack.