Astro Pneumatic ADG100 Manual - Página 5

Procurar online ou descarregar pdf Manual para Adaptador Astro Pneumatic ADG100. Astro Pneumatic ADG100 7 páginas. Grease gun drill adapter

Imprimir página

MODEL:

ADG100

VIII. INSTRUCTIONS FOR 3 DIFFERENT LOADING METHODS OF GREASE GUN

RECOMMENDATION:

1. If loading grease by cartridge, note that the Rubber Plunger may change shape over time due to

prolonged squeezing of grease cartridge. Inspect during changes.

2. A misshaped rubber plunger may then cause a small amount of leak-by at the stopper and plunger

handle when switching to Dispenser or Bulk loading grease.

3. Thus it is recommended to pick a method of grease loading and stick to this method in the future for

best results.

FOLLOW THESE STEPS CAREFULLY BEFORE USING THIS GUN

CARTRIDGE LOADING

1. Remove gun head from container tube.

2. To remove an empty cartridge, pull back on the follower handle until the follower

rod is fully extended. Then, release the stopper lock and allow the follower handle

to lower the empty cartridge from the container tube. Pull back on the follower

handle. When the follower rod is fully extended, the stopper should hold the

rod extended.

3. Remove the caps from both ends of the new grease cartridge and insert the

open cardboard end of the cartridge into the container tube with the metal

rimmed end out.

4. Loosely assemble the gun head and the container tube. Release the stopper lock

and allow the follower handle to go free.

5. Unscrew the container tube 1-2 turns from the gun head and push down on the

follower handle until grease oozes from the outlet of the gun head. Tighten

container tube into the gun head securely.

• Please make sure that the end of the grease cartridge that has been inserted

into the container tube is not damaged, had its cardboard rim folded and

remains in an exact round shape. Otherwise the plunger rubber will be

prevented from entering into the grease cartridge and grease cannot be forced

out. If this case happens correct the above errors. Grease can be pumped out

only it the above errors have been corrected.

• Do not re-use the empty grease cartridge again after using it.

• Application of some grease on the plunger rubber will make it easier to enter

into the grease cartridge.

DISPENSER LOADING

1. Remove slotted plug from head assembly and insert the proper loader fitting that

adapts to pump being used.

2. Extend level out on the grease gun and insert the loader fitting into pump adapter and fill.

NOTE : Always remove used cartridge from gun when bulk filling.

PRODUCT TYPE:

GREASE GUN DRILL ADAPTER

Page 5

FOLLOWER HANDLE

GREASE

CARTRIDGE

FOLLOWER

ROD

CONTAINER

TUBE

CARTRIDGE LOADING

DISPENSER