Canon Microfilm Scanner 400 Manual de instruções - Página 24

Procurar online ou descarregar pdf Manual de instruções para Scanner Canon Microfilm Scanner 400. Canon Microfilm Scanner 400 34 páginas. Compact film scanner

Imprimir página

OPERATING PROCEDURES

Using trimming

Use the trimming feature to crop and print only a selected portion

of an image.

What is trimming?

Trimming means selecting only a portion of an image and crop-

ping it for printing. Only the trimmed or cropped area of the im-

age is printed. For example, you could trim a single article from a

full page of newspaper print and print only the article enclosed in

a trimmed rectangle.

To select trimming, press the Border key on the operation panel

until the lamp next to the trimming icon lights ( ). Follow the

procedure below to define the area to the image to be printed.

Defining an area for trimming

1. Press and hold down the Border key for approximately 5 seconds

until the lamp for trimming ( ) starts blinking.

The current area setting is shown in the Print display.

2. To adjust the area setting, press the Print Number Setting keys.

The starting point or origin for defining the screen area is the lower

right corner of the screen.

Plus key

Minus key

For example, the illustration shows the vertical set for 4 and the

horizontal set for 7. The shaded area is the area trimmed and se-

lected for printing.

3. To save the setting, press the Border Button. The setting remains

in effect even after the power is turned off and turned again.

If you have installed the optional Framing Kit, you can-

not use this method to set an area on the screen. Use

the area setting tapes to define an area.

Press to move in the vertical direction. The

number in the Print display shows the current

screen vertical coordinate.

Press to move in the horizontal direction. The

number in the Print display shows the current

horizontal coordinate.