flying Thinz Mad 3D Taco Manual de instruções - Página 7
Procurar online ou descarregar pdf Manual de instruções para Brinquedo flying Thinz Mad 3D Taco. flying Thinz Mad 3D Taco 14 páginas. An all out 3d fun fly plane
Imprimir páginaInstall Control Surfaces
1/2A Hinges
Use a hinge as a guide to mark both the wing and the aileron
where the hinge locations will be. The wing half should have 4
hinges evenly spaced apart from each other.
Repeat this step for the rudder and elevators. The rudder uses
3 hinges and the elevator uses 2 hinges per side.
Using a hinge slotting tool, make a slit in the foam at the
locations marked in the previous step. With a small amount of
glue, install the hinges into the wing. If a hinge tool is not avail-
able, use your best judgement for centering the slits where the
hinges will install.
Repeat this step for the rudder and elevators.
Install the aileron using a small amount of epoxy. Move the
ailerons up and down so that the hinge pins don't get stuck.
Tip: Applying a small amount of vaseline or oil to the hinge
pin will help prevent it from getting gummed up with glue.
Finally, repeat the same process for the rudder and elevator.
Keep moving the control surfaces to assure they don't get stuck.
Tape Hinges (Optional Method)
Optional: Apply the first strip of tape to the wing or stab. Place
the control surface at the angle that was created on the control sur-
face and attach tape to the control surface.
Optional: Move the control surface to the opposite side and add
an additional strip of tape to the other side.
Optional: The finished taped hinge control surface.
7