Advance acoustic 56380772 Manual do operador - Página 4

Procurar online ou descarregar pdf Manual do operador para Máquina de chão Advance acoustic 56380772. Advance acoustic 56380772 13 páginas.

KNOW YOUR MACHINE DESCRIPTIONS

Operator Handle (1): Operator holds onto this handle to move the machine from one location to

another.

Solution Tank Lid (2): This lid screws off so the tank can be filled. The solution fill hose is

tethered to the lid, and hangs inside the arm of the Operator Handle.

Recovery Tank Lid (3): This lid covers the opening in the Recovery Tank. This is where the operator

can access the tank to clean it and the ball float cage. The tank can be flushed out by running clean

warm water into this opening and laying the open drain hose into a bucket or drain.

Recovery Hose (4): Waste water is picked-up through this hose.

Spray Hose (5): This hose delivers water from the machine to the cleaning tool.

Drain Hose (6): This hose is used to empty the recovery tank. NOTE: hold the end of the hose above

the water level in the tank to avoid sudden, uncontrolled flow of waste water when you remove the

cap, then lower the hose slowly to control the rate of discharge.

Quick Disconnect (7): Point of attachment for the Spray Hose (5).

Tools & Accessories (8): Various accessories can be stored on the machine.

Castors and Wheels (9): Castors pivot for ease of steering, and large back wheels make it easy to

roll the machine from location to location.

Recovery Hose Inlet (10): Point of attachment for the Recovery Hose (4).

Chemical Feed Lines (11): These clear tubes connect the cleaning chemical containers to the

machine where the chemical can be siphoned into the outlet water from the pump. Metering tips --

used to change the ratio of water to chemical -- are installed here.

Switch Plate (12): The machine's on/off switches for the vacuum and for the pump are located here

and this is where the valve to change chemical feeds is located.

Power Cord (13): The 25 ft. power cord connects to a power cord pigtail on the rear of the machine.

Chemical Container Holders (14): Two molded-in bottle holders for chemical jugs.

1 1