coldline SB36-N Manual do utilizador - Página 7
Procurar online ou descarregar pdf Manual do utilizador para Frigorífico coldline SB36-N. coldline SB36-N 9 páginas. Commercial refrigerator and freezer
Imprimir páginaTROUBLE SHOOTING
Before requesting any service on your unit, please check the following points.
Please note that this guide serves only as a reference for solutions to common
problems.
SYMPTOM
Compressor not running.
Condensing unit runs for long
periods of time.
Cabinet temperature is too
warm.
POSSIBLE CAUSE
Fuse blown or circuit breaker
tripped.
Power cord unplugged.
Thermostat set too high.
Cabinet in defrost cycle.
Excessive amount of warn
product placed in cabinet.
Prolonged door opening or
door ajar.
Door gasket(s) not sealing
properly.
Dirty condenser coil.
Evaporator coil iced over.
Thermostat set too warm.
Blocking air flow.
Excessive amount of warm
product placed in cabinet.
Fuseblown or circuit breaker
tripped.
Dirty condenser coil.
Prolonged door opening or
door ajar.
Evaporator coil iced over.
USRESTAURANT® RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE
CORRECTIVE ACTION
Replace fuse or reset circuit
breaker.
Plug in power cord.
Set thermostat to lower
temperature.
Wait for defrost cycle to
finish.
Allow adequate time for
product to cool down.
Ensure doors are closed
when not in use. Avoid
opening doors for long
periods of time.
Ensure gaskets are snapped
in completely. Remove
gasket and wash with soap
and water. Check condition
of gasket and replace if
necessary.
Clean the condenser coil.
Unplug unit and allow coil to
defrost. Make sure
thermostat is not set too cold.
Ensure that door gasket(s)
are sealing properly.
Set thermostat to lower
temperature.
Re-arrange product to allow
for proper air flow. Make sure
there is at least four inches of
clearance fromevaporator.
Allow adequate time for
product to cool down.
Replace fuse or reset circuit
breaker.
Clean the condenser coil.
Ensure doors are closed
when not in use. Avoid
opening doors for long
periods of time.
(see above)