Air Hogs Jet Set Manual de instruções

Procurar online ou descarregar pdf Manual de instruções para Brinquedo Air Hogs Jet Set. Air Hogs Jet Set 3 páginas.
Também para Air Hogs Jet Set: Manual de instruções (4 páginas)

Imprimir página

FCC Statement: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) This device must accept any interference received, including interference that

may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B digital devices

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to

radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that

interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can

check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:

• Reorient or relocate the receiving antenna • Increase the separation between the toy and the radio or the TV • Consult the dealer or

an experienced TV-radio technician for help. NOTE: Changes, adjustments or modifications to this unit, including but not limited to,

replacement of any transmitter component (crystal, semiconductor, etc.) could result in a violation of FCC rules under part 15

and/or 95 and must be expressly approved by Spin Master Ltd. or they could void the user's authority to operate the equipment.

CANADIAN Class B statement: This class B digital apparatus meets all the requirements of the Canadian Interference-Causing

Equipment Regulations. This Category II radio communication device complies with Industry Canada Standard RSS-310.

Your Air Hogs

Jet Set™ is equipped with a

BATTERY SAFETY INFORMATION:

Lithium Polymer battery.

• Requires 6 x 1.5-V AA batteries (not included).

• Batteries are small objects.

SPECIAL LiPO BATTERY INSTRUCTIONS:

• Replacement of batteries must be done by adults.

• Never charge battery unattended.

• Follow the polarity (+/-) diagram in the battery

• Charge battery in isolated area. Keep away from flammable materials.

compartment.

• Do not expose to direct sunlight.

• Promptly remove dead batteries from the toy.

• There is a risk of the batteries exploding, overheating, or igniting.

• Dispose of used batteries properly.

Do not disassemble, modify heat, or short circuit the batteries.

• Remove batteries for prolonged storage.

Do not place them in fires or leave them in hot places.

• Only batteries of the same or equivalent type as

• Do not drop or subject to strong impacts.

recommended are to be used.

• Do not allow the batteries to get wet.

• DO NOT incinerate used batteries.

• Only charge the batteries with the specified Spin Master™

• DO NOT dispose of batteries in fire, as batteries may

battery charger.

explode or leak.

• Only use the batteries in the device specified by Spin Master™.

• DO NOT mix old and new batteries or types of batteries

• Carefully read the instruction guide, and use the batteries correctly.

(i.e. alkaline/standard).

• In the unlikely event of leakage or explosion use sand or a chemical

• DO NOT use rechargeable batteries.

fire extinguisher for the battery.

• DO NOT recharge non-rechargeable batteries.

• Batteries must be recycled or disposed of properly.

• DO NOT short-circuit the supply terminals.

PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed, product disassembly and battery removal must

be performed by an adult. Do not use any tools for disassembly. Pulling, tearing, and deforming of the product during disassembly,

while necessary, should be as limited as possible. Do not compress the product at any time. Ensure product is turned off. Find a

point where the two body halves meet; the nose of the aircraft or where the wing meets the body. Start to peel the halves apart,

separating them where they are glued together; remove any tape as necessary. Separate product body halves to expose internal

electronics. To separate battery from product use scissors to cut a single battery wire, immediately wrap the cut wire end with tape

to isolate it, repeat until all battery wires are cut and isolated. Dispose of battery in accordance with your local battery recycling or

disposal laws. NOTE: Opening of product and/or removal of battery will render product inoperative and voids manufacturer

warranties, dispose of remaining product components in accordance with local laws.

Contains 1 x 3.7 V LiPo battery(s). Batteries or

DAMAGED OR BROKEN, DO NOT FLY.

battery packs must be recycled or disposed of

properly. When this product has reached the end

FLYING WITH BROKEN PROPELLER(S) MAY

of its useful life it should not be disposed of with

other household waste. The Waste Electrical and

CAUSE DAMAGE OR LEAD TO INJURY.

Electronic Equipment Regulations require it to be

separately collected so that it can be treated using the best available

recovery and recycling techniques. This will minimize the impact on the

environment and human health from soil and water contamination by any

hazardous substances, decrease the resources required to make new

your fingers, hair, eyes and other body parts. Do not launch flying toy

products and avoid using up landfill space. Please do your part by keeping

at people or animals.

this product out of the municipal waste stream! The "wheelie bin" symbol

Carrier frequency 27.145 MHz. Field strength: 67.4dBuV/m at 3m.

means that it should be collected as "waste electrical and electronic

equipment". You can return an old product to your retailer when you buy a

similar new one. For other options, please contact your local council.

Hereby, Spin Master Ltd., declares that this

Jet Set™ is in compliance with the essential

requirements and other relevant provisions of

Directive 1999/5/EC. <http://www.airhogs.com>

SPIN MASTER LTD., 450 FRONT STREET WEST, TORONTO,

Air Hogs

ON M5V 1B6 CANADA

reserved. This product conforms to safety requirements of ASTM

Customer Care: 1-800-622-8339 Fax: 416-364-8005

F-963, EN-71 & CHPA. • Please retain this information for future

Email: [email protected]

reference. • Please remove all packaging materials before giving to

Spin Master Inc., PMB #10053, 300 International Drive, Suite 100,

children. • An adult should periodically check this toy to ensure no

Williamsville, NY 14221, USA

damage or hazards exist, if so, remove from use. • Children should

be supervised during play. • Keep addresses and phone numbers

for future reference. • The item inside this package may vary from

Imported into EU by:

the photographs and/or illustrations. MADE IN CHINA.

SPIN MASTER INTERNATIONAL, S.A.R.L.,

16 AVENUE PASTEUR, L-2310, LUXEMBOURG

20043697 GTL English REV 1

www.spinmaster.com

T44398_0009_20043697_GTL_IS_R2

HOW TO INSTALL YOUR BATTERIES

BATTERY INSTALLATION – CONTROLLER/CHARGER

1. Open the battery door with a screwdriver (pic.1). 2. If used batteries are present, remove these batteries from

the unit by pulling up on one end of each battery. DO NOT remove or install batteries using sharp or metal tools.

3. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment (pic.2). 4. Replace

battery door securely (pic.3). 5. Check your local laws and regulations for correct recycling and/or battery disposal.

pic.1

HOW TO CHARGE YOUR JET SET™

IMPORTANT CHARGING INFORMATION

• Before taking your initial flight, charge the plane for a complete charge cycle on your charger.

• Depending upon the length of future play, you will not need to complete a full charge before each flight.

NOTE: A shortened charge results in a shorter playtime (may take up to 1/2 hour to fully charge).

For best performance, use new batteries only and let motor cool for 10-15 minutes between charges.

1. Set the switch on the

2. Set the controller/

3. Insert charge rod of

jet to OFF.

charger switch to CHG.

controller/charger into

charge plug of jet

aligning jet with charger

as shown.

PRE-FLIGHT ENVIRONMENT CHECK

1. Location – Fly in a large wide-open, grassy location that is free of buildings, trees, overhead wires, and other

obstructions. Do not fly near people or animals.

2. Weather – Fly on mild, sunny days. Do not fly in electrical storms, rain, sleet, snow or other adverse weather

conditions. Do not fly if the temperature is below 7°C/45°F. In very cold temperatures, the plane will become fragile

and the engine performance will decrease.

3. Wind Conditions – Do not fly in strong wind. Strong winds may overpower the jet and make it difficult to control.

In windy conditions, it may appear as though you have no control over the jet.

FLYING INSTRUCTIONS

1. Fully extend controller/

3. Power indicator will

5. When launching the jet, use

charger antenna.

light up.

partial throttle. Refrain from

using the directional stick at

initial launch. Launch the jet into

the wind and parallel to the

ground. When preparing for take

off, check the direction of the

wind. Always launch your plane

into the wind for the best take

off and flight results.

2. Set controller/

4. Set jets switch to ON.

charger switch to ON.

Contents:

1 Air Hogs

1 Controller/Charger

2 Spare Propellers

(left and right)

1 Instruction Guide

WARNING: IF PROPELLER(S) BECOME

WARNING: The antenna is not to be inserted into socket outlets.

CAUTION: Never fly near your face. Keep propeller away from

Experience radio-controlled flight with the Air Hogs

& easy! Just choose the direction you want to fly and move the controller throttle stick. The

Warning:

CHOKING HAZARD –

ultra-light Jet Set™ is powered by a lithium polymer battery for long flights, features precision

Small Parts.

speed control and damage-

resistant foam. The Jet Set™

also includes an integrated

controller/charger unit for

convenient portability and

easy handling on the field.

Perfect for outdoor flights.

pic.2

pic.3

4. The charging LED will

flash. When charging is

complete, both charge and

power indicators will flash

concurrently. Remove jet

from controller/charger.

If the jet turns

right involuntarily,

turn the trim knob

to the left until the

jet flies straight.

PROBLEM

Jet will not start or has

low power.

REPAIRS

If the wings on

your jet get

damaged they can

Jet will not turn.

be easily repaired

with clear tape as

shown.

Repair

Jet is flying too low.

Jet is flying too high.

Motors don't stop

when controller/charger

turned OFF.

NOTE: If normal function of the product is disturbed or interrupted, strong electro-magnetic interference may be causing the

issue. To reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to

another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.

INSTRUCTION GUIDE

Vertical

Jet

Stabilizer

Charge

Port

Propeller

Antenna

Throttle

Stick

(Speed

Control)

Charge

Rod

Controller/Charger

Jet Set™! The Jet Set™ makes flying fun

ALSO AVAILABLE

CONTROLLING JET FLIGHT

1. To make the jet climb, move the throttle

stick forward. Too much throttle can cause

a stall. To ACCELERATE upwards, move

the throttle stick further UP.

2. To FLY LEFT,

3. To FLY RIGHT,

move the direction

stick left.

stick right.

4. To LAND,

select a soft

grassy area

and pull the

throttle stick

back slowly.

TRIMMING YOUR JET

If the jet turns left

involuntarily, turn

the trim knob to

the right until the

jet flies straight.

TROUBLESHOOTING

CAUSE

SOLUTION

1. Jet not charged.

1. Charge jet for a complete charge cycle.

2. Battery power is drained.

2. Replace the controller/charger batteries after

3. Jet was not set to OFF during

approximately 8 to 10 flights.

charging.

3. The jet won't accept a charge in the ON position.

4. Controller/charger was not set

Always set to OFF before charging.

to CHG while trying to charge.

4. The controller/charger will NOT charge in the OFF

or ON position. Always set the controller/charger to

CHG before attempting to charge.

1. Controller/charger is not ON.

1. Set controller/charger to ON.

2. Controller/charger antenna is

2. Fully extend controller/charger antenna before flying.

not extended.

3. Do not fly in strong winds. Strong windy conditions will

limit and prevent your ability to control the jet.

3. It's a windy day.

1. Needs more power.

1. Push the throttle UP.

2. The six AA batteries in the

2. Charge jet for a complete charge cycle or, if batteries

controller/charger are drained.

are completely drained, replace batteries.

Need to decrease power.

Pull the throttle DOWN.

Radio interference from some

Turn the switch on the plane to OFF.

other source.

8-10

YRS

WARNING:

CHOKING HAZARD

– Small parts.

Not for Children under 3 years.

Fold 1

Main Wing

Propeller

Canard

Fuselage

Jet Set™

Direction Stick

(LEFT/RIGHT)

Steering Trim Knob

Power Indicator

Charging Indicator

Power Switch

(ON/OFF/CHG)

Fold 2

Folding

Instructions