Canon imagePROGRAF W6400 Manual do utilizador - Página 23
Procurar online ou descarregar pdf Manual do utilizador para Software Canon imagePROGRAF W6400. Canon imagePROGRAF W6400 34 páginas. Hdi driver guide
Também para Canon imagePROGRAF W6400: Brochura e especificações (8 páginas), Brochura e especificações (12 páginas), Manual do condutor (24 páginas)
Imprimir página
Media Configuration Tool Guide
The following settings are available for Far End Margin.
Far End Margin
5 mm
10 mm
Important
c. From the Printhead Height Adjustment Lever Setting Position list in Roll Paper
Margin for Safety set the position of the printhead height adjustment lever set with the
printer to match the media.
The following settings are available for Printhead Height Adjustment Lever Setting
Position.
Printhead Height
Adjustment Lever Setting
Position
Upper
Middle (Standard)
Lower
5. Set the thickness of the media to be added from the Media Thickness list.
The following settings are available for Media Thickness.
Media Thickness
Thick
Chapter 4 Adding Media Types
Setting
For media that has no problem when
printing with a standard size margin.
When printing an image at the very end
of the end margin, the cutter touches the
page before the ink has dried and dirties
the printed image. This setting sets the
margin about 5 mm (in the feed
direction) longer than the standard
margin for the media size.
When you set the margin smaller, the printed image may not print
properly or, with some media, the printhead may scratch the
surface.
Setting
For media that has a strong tendency to
curl, causing the printhead to scratch
the surface.
Before you start a print job, check the
setting of the printhead height
adjustment lever.
For standard media.
Select this setting to print fine, delicate
lines of the highest precision as in a
CAD design or drawing.
However, the ink absorption
characteristics of some media may
cause the printing surface to ripple when
the ink is absorbed, causing the
printhead to scratch the surface of the
printout. You should become familiar
with the properties of the media and do
the setting and limit such printing to
media that will not cause rippling.
Example: Film, etc.
Before you start a print job, check the
setting of the printhead height
adjustment lever.
Setting
Select this when the media set is thick,
or when the printhead scratches the
surface.
4-6