Daekyung DTR-300N Manual de operação - Página 10

Procurar online ou descarregar pdf Manual de operação para Equipamento de teste Daekyung DTR-300N. Daekyung DTR-300N 15 páginas. Rockwell hardness tester

Imprimir página

5.11.2 If Ø has been entered after the test, the calibration value is displayed.

6. Installation and Test Procedures

6.1 The tester should be installed in the stable place without dust, humidity, or vibration.

6.2 After installing the machine on the strong support, make a hole for the test at the diameter of 90 mm and the

depth of 160 mm on the support located in the screw lower part. This makes it possible to lower the screw.

6.3 After installing the machine on the support, unpack the machine and align the level to prevent the

machine from shaking. To align the level, unfasten the equipment cover (⑪) by using a hexagonal

wrench and align the dead weight and the dead weight support in line by using a level adjustment screw.

6.4 Clean the contact surface of the Anvil (④), remove foreign materials and oil, and then insert the anvil to the machine.

6.5 Select a scale appreciate for the specimen and insert a diamond cone or a steel

ball indenter matching with the scale. Set the dead weight (60, 100, 150 kgf)

adjustedfor the scale by using the dead weight adjustment handle (⑫).

6.6 Turn on the Main S/W (⑧). At this time, check if the main power is turned on. If

not, connect the Cord Connector (⑨). The lighting LAMP (②) is turned on.

6.7 Put the specimen on the Anvil (④) and turn the Screw Handle (⑥) in the right

direction. If the the mark (>) of the Digital Display part is progressed to the end

of >>>>>>>> (Gauge 2.900 mm or more), the test is started along with the

'beep' buzzer sound as the lighting lamp (②) is turned off.

※ The procedure is as follows:

2. Wait Hold Time

6. Wait Load Time :

→ D. Load Time Setting Value

8. Wait Read Time :

→ D. Read Time Setting Value

DAEKYUNG TECH & TESTERS Mfg. CO.,LTD

⇨ 3. Load Weight : Motor operation ⇨

7. Remove Weight :

⇨

Motor operation

⇨ Display of Hardnes Value

⇨

- 10 -