Asus A7N8X-LA Explorer 2 Manual do utilizador - Página 12
Procurar online ou descarregar pdf Manual do utilizador para Placa-mãe Asus A7N8X-LA Explorer 2. Asus A7N8X-LA Explorer 2 18 páginas. Microatx motherboard
Imprimir página
6.
Connectors
This section describes and illustrates the internal connectors on the motherboard.
1. Floppy disk drive connector (34-1 pin FLOPPY1)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the floppy
drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables
with pin 5 plug).
A7N8X-LA/Explorer2
A7N8X-LA/Explorer2
Floppy Disk Drive Connector
2. ATX power connectors (20-pin ATXPWR1)
These connectors connect to an ATX 12V power supply. The plugs from the
power supply are designed to fit these connectors in only one orientation. Find
the proper orientation and push down firmly until the connectors completely fit.
Make sure that your ATX 12V power supply can provide 8A on the +12V lead
and at least 1A on the +5-volt standby lead (+5VSB). The minimum
recommended wattage is 230W, or 300W for a fully configured system. The
system may become unstable and may experience difficulty powering up if the
power supply is inadequate.
A7N8X-LA/Explorer2
A7N8X-LA/Explorer2
ATX Power Connector
8
ASUS A7N8X-LA (Explorer 2) Motherboard
FLOPPY1
NOTE: Orient the red markings on
the floppy ribbon cable to
PIN 1
ATXPWR1
+12.0VDC
+5.0VDC
+5VSB
+5.0VDC
PWR_OK
-5.0VDC
COM
COM
+5.0VDC
COM
COM
COM
+5.0VDC
PS_ON#
COM
COM
+3.3VDC
-12.0VDC
+3.3VDC
+3.3VDC
PIN 1