Advance acoustic SD 17 Manual de instruções de utilização - Página 9

Procurar online ou descarregar pdf Manual de instruções de utilização para Máquina de chão Advance acoustic SD 17. Advance acoustic SD 17 14 páginas.

Imprimir página

INTRODUCTION

This manual will help you get the most from your Nilfisk-Advance floor

machine. Read it thoroughly before operating the machine.

This product is intended for commercial use; polishing, spray buffing, scrubbing,

stripping and rotary carpet shampooing.

PARTS AND SERVICE

Repairs, when required, should be performed by your Authorized Nilfisk-

Advance Service Center, who employs factory trained service personnel, and

maintains an inventory of Nilfisk-Advance original replacement parts and acces-

sories.

Call the NILFISK-ADVANCE DEALER named below for repair parts or service.

Please specify the Model and Serial Number when discussing your machine.

(Dealer, affix service sticker here.)

NAME PLATE

The Model Number and Serial Number of your machine are shown on the

Nameplate on the bottom of the machine. This information is needed when

ordering repair parts for the machine. Use the space below to note the Model

Number and Serial Number of your machine for future reference.

MODEL NUMBER

SERIAL NUMBER

UNCRATE THE MACHINE

When the machine is delivered, carefully inspect the shipping carton and the

machine for damage. If damage is evident, save the shipping carton so that it

can be inspected. Contact the Nilfisk-Advance Customer Service Department

immediately to file a freight damage claim.

(A)-KNOW YOUR MACHINE

Operator Handle Grips

Switch Lever Safety Lock Button

Switch Levers - Squeeze - ON / Release - OFF

"Kwik Lok" Handle Adjustment Lever

Power Cord

Operator Handle

WARNING!

This machine contains moving parts. To reduce the risk of injury,

always unplug the power cord before servicing.

8 - FORM NO. 56041445 - SD 17/ SD 20

(B)-INSTALLING THE BRUSH OR PAD

HOLDER

Align the lugs with the corresponding slots in the brush or pad holder and turn

the brush or pad holder counterclockwise to lock it in place. To remove brush/

pad holder, give it a quick, hard turn clockwise.

CAUTION!

Using the wrong brush or pad on this machine can damage the

floor or overload the motor.

OPERATION

Unwrap the Power Cord and plug it into a properly grounded outlet.

Loosen the foot operated "Kwik Lok" lever with the toe of your foot by

pulling up on the bottom of the lever. Move the Operator Handle

downward until your arms are almost straight. Then step down on top

of the lever to lock it.

Lift the Handle until the brush (or pad) is flat against the floor.

WARNING!

Be prepared to control the machine as soon as the motor starts.

Just a slight up or down movement of the Handle will make the

machine move from side to side. Raise the Handle to go right.

Lower the Handle to go left.

CAUTION!

Immediately start moving the machine back and forth. Keep the

machine moving while the motor is running to avoid damage to

the floor or carpet.

Hold one of the Operator Hand Grips firmly, push the Safety Lock

Button and then compress the switch levers to start the motor. NOTE:

When the dual controlled switch levers are released, the machine shuts

off immediately.

NOTE: When spray buffing, check the pad every 15 minutes for dirt and

wax build-up. If the pad is dirty, turn it over to expose the clean side or

install a clean pad.

revised 12/01