Canon LV-5200 Manual do Proprietário - Página 42
Procurar online ou descarregar pdf Manual do Proprietário para Projetor Canon LV-5200. Canon LV-5200 48 páginas. Canon lv-5200: user guide
Também para Canon LV-5200: Brochura e especificações (2 páginas)
Imprimir página
APPENDIX
Before calling your dealer or service center for assistance, check the following:
G Make sure you have connected the projector to peripheral equipment as described properly in the section "CONNECTING
THE PROJECTOR" on pages 11 ~ 13.
G Verify that all computer, video and power cord are properly connected and turn the equipment on.
G When you are operating the projector with a computer and it does not produce an image, restart the computer.
G Select the other input source.
Problem:
No power.
Image is out of
focus.
Picture is Left/Right
reversed.
Picture is
Top/Bottom
reversed.
Some displays are
not seen during the
Operation.
No image.
No sound.
Computer 1 cannot
be selected.
42
TROUBLESHOOTING
G Plug the projector into an AC outlet.
G Make sure the READY Indicator lights.
G Wait 90 seconds after the projector is turned OFF before turning the projector back on.
NOTE : After pressing the Power ON-OFF button to OFF, make sure the projector works as
follows:
1. The LAMP indicator lights bright and the READY indicator turns off.
2. After 90 seconds, the READY indicator lights green again and the projector can
be turned on by pressing the Power ON-OFF button.
G Check the WARNING TEMP. indicator. If this indicator flashes red, the projector cannot
be turned on.
(See the "TURNING ON/OFF THE PROJECTOR" section on page 19.)
G Check the Projection Lamp. (Refer to page 38.)
G Adjust the focus of the projector.
G Make sure a projection screen is at least 3.6' (1.1m) from the projector.
G Check the Projection Lens to see if it needs cleaning.
NOTE : Moving the projector from a cool temperature location to a warm temperature
location may result in moisture condensation on the Projection Lens. In such an
event, leave the projector OFF and wait until condensation disappears.
G Check Ceiling / Rear feature. (See the "SETTING" section on page 36.)
G Check Ceiling feature. (See the "SETTING" section on page 36.)
G Check Display feature.(See the "SETTING" section on page 36.)
G Check the connection between your computer or video equipment and the projector.
G Check the NO SHOW function. (Refer to P21.)
G When turning the projector on, it takes about 30 seconds to display an image.
G Check the system that you select is corresponding with your computer or video
equipment.
G Make sure the temperature is not out of the Operating Temperature (5°C ~ 35°C).
G Check the audio cable connection from the audio input source.
G Adjust the audio source.
G Press the VOLUME (+) button.
G Press the MUTE button.
G Check RGB IN 1 / OUT terminal is set as COMPUTER 1.
on page 36.)
Try these Solutions
(See the "SETTING" section