dormak CR43 Manual do operador - Página 7
Procurar online ou descarregar pdf Manual do operador para Cortador de relva dormak CR43. dormak CR43 12 páginas.
Imprimir página
2.4. cables
All extension cords to be used must
meet the minimum sections listed on the
following table:
Voltage
cable
length
230 V / 50 Hz
Up to 20 m
230 V / 50 Hz
20 – 50 m
2.5. preparing
1. When operating the machine always wear
protective clothing, which includes safety
shoes and long straight trousers.
2. Be sure that there are no sticks, stones,
wires or any kind of object on the lawn that
might be ejected by the machine or damage
the blades.
3. Before using the machine or if a electric
shock occurs, check if there is any damaged
or worn element; if so, it must be immediately
replaced.
4. Whenever the blades are replaced, we
recommend the replacement of the whole
cutting unit, to avoid imbalances.
2.6. operating
1. Work only at daylight or under good
artificial lighting.
2. Do not mow when the grass is wet, neither stand
barefoot on it.
3. When mowing on steep slopes be careful
about slipping; wear adequate shoes.
4. Always mow crossways to the slope, never
upwards or down-wards.
5. Be particulary careful when changing
direction, specially on slopes.
MiniMuM
diaM.
6. Always work at walking speed, do not run.
1.5 mm
2
2.5 mm
2
7. Keep a safe and stable position, specially
on slopes. Do not use the machine near pools
or wells.
8. Be particulary careful when mowing in
reverse, there is the risk of stumble.
9. Do not mow pulling the machine towards you.
10. Never lift or carry the appliance when
it is functioning, specially over non lawny
sufarces.
11.Never operate the machine when its safety
devices are damaged or bad positioned.
12. Keep your hands and feet away from
the cutting elements, specially if the engine
is running. During repairing or checking
procedures on cutting elements always
wear gloves and adequate clothing. These
procedures must always be made when
the engine is switched off and the machine
completely disconnected from the power
suplly.
13. Do not tilt the equipment when the
engine is running or if it is connected to the
power supply.
14. Keep your hands away from grass
discharge slot.
07