Canor SH-1 Manual do utilizador - Página 2

Procurar online ou descarregar pdf Manual do utilizador para Amplificador Canor SH-1. Canor SH-1 3 páginas.

10. Power source - the device must be connected only to a power supply, for which it is

proposed.

11. Power cord - it is necessary to pay particular attention to a power cord, it must be

positioned so as to avoid stepping on it and to ensure it is protected against mechanical

damage.

12. The longer the period during which you do not use the preamplifier – you should

disconnect the power cord from the mains supply, or at least turn off the main power switch

located on the front panel.

13. Subjects containing liquid - do not place these objects (vases, flower pots), so that they

can fall on the preamplifier, possibly a fluid could leak out of them on the unit.

14. Damage requiring service - equipment should be repaired only to qualified service.

Once:

a) power cord is damaged

b) the device fell into the water or was poured

c) the device was exposed to rain

d) the device works incorrectly

e) the device fell to the ground or is otherwise mechanically damaged.

15. Repairs - all repairs must be entrusted to qualified service.

16. General warning - use the device only in accordance with the instructions.

Caution! To help you avoid an electric shock, do not expose the amplifier to

rain or moisture.

Signal and headphones connections

Signal input and output connections: The input connections are made via input socket at the

rear of the unit. Inputs and outputs use RCA connectors and should be connected in

accordance with the standard convention – right channel – RED – left channel – WHITE.

Headphones output connections are made via the standard 3 - pole 6,3mm jack plug.

Caution! Make all connections only if the device is disconnected from the

mains

Switching on

If you have already connected all signal sources and speakers, connect the amplifier to the

mains. Please ensure the position of the volume control is fully counterclockwise (zero

volume).

Turn the amplifier on with power switch located at the front of the unit.

Operate the input source and increase the volume control in a clockwise direction until an

audio signal is observed and you hear the sound from the speakers. If for any reason no output

is observed, please refer to the trouble-shooting guide.

Trouble-shooting guide

The amplifier is completely broken: power cord is not properly connected to the mains

Solution: connect the cable properly