Boltek EFM-INV2 Manual de instruções de instalação - Página 11

Procurar online ou descarregar pdf Manual de instruções de instalação para Racks & Stands Boltek EFM-INV2. Boltek EFM-INV2 13 páginas. Inverting mounting kit

Imprimir página
DO NOT ALLOW FIELD MILL TO ROTATE OR WIRES CONNECTING FIELD MILL WILL TWIST
COAT BOTH SIDES OF RUBBER WASHER WITH SILICONE GREASE.
FAILURE TO PROPERLY TIGHTEN NUT ONTO RUBBER WASHER AND SHROUD WILL RESULT IN
WATER DAMAGE TO FIELD MILL NOT COVERED BY WARRANTY
Attach junction box to the bottom of the inverted mast if not pre-assembled. Remove
tightening nut and rubber insert from the strain relief, then screw into the bottom of the
junction box.
(C) 2020 BOLTEK CORP
Slide the strain relief nut onto the cable, then insert cable into the
junction box with a wide loop and insert into connector. Secure the
cable with the rubber insert and tighten nut onto strain relief. Screw
the cover plate onto the junction box.
10/15/2020
EFM-INV_Instruction_1.3