canty KD-51 Easycut Instrução original - Página 2

Procurar online ou descarregar pdf Instrução original para Cortador canty KD-51 Easycut. canty KD-51 Easycut 4 páginas. Hot wire foam cutter

Introduction

The KD-51 Hot Wire Cutter is a professional-grade hot cutting machine for foamed plastics.

The KD-51 Hot Wire Cutter heats up in seconds and gives the Button switch.

Recommended Use

Expanded Polystyrene (EPS), Extruded Polystyrene (XPS), can be

easily cut with cutting procedures.

Wire Installation

NOTE: Always unplug the power cord

of the KD-51 Hot Wire Cutter before

installing or removing the wire. Allow

sufficient cooling time for wire and wire

holders (Springs)

One pull the 2pieces of spring with drag hook at same time(Not pull overdo), and partner put up the wire

to the springs.

Caution 1: Excessive power output and heat generation may cause the damage to the tansformer. Use only the

power output for proper cutting. The wire does not need to be red hot to move through foamed plastics.

Plywood Flat Board

Back Stand

Guider Ruler

(4-100cm,0º-75º)

Original instruction

Transformer

Hot Wire

Aluminium Bow

Middle Plate

Right Side Plate

Side Guider Ruler

Front Stand