Battery Doctor 20093 Manual do Proprietário

Procurar online ou descarregar pdf Manual do Proprietário para Carregador de bateria Battery Doctor 20093. Battery Doctor 20093 4 páginas. 2/10/55 amp battery charger & maintainer instructions for 6 & 12 volt batteries

Imprimir página

Problem

Possible Cause

The charger is making an audible

Circuit breaker is cycling.

clicking sound.

Battery is defective.

Shorted battery cables or clips.

Severely discharged batter, but

otherwise it is a good battery.

Reverse connections at battery.

Charger makes a loud buzz

Transformer laminations vibrate (buzz).

or hum.

Shorted diode assembly of output

rectiﬁ er assembly (hum).

Short or no start cycle when

Drawing more than the Engine Start

cranking engine.

Rate.

Failure to wait 4 minutes between

cranks.

Clips are not making a good connection.

AC cord and/or extension cord is loose.

No power at receptacle.

The charger may be overheated.

Battery may be severely discharged.

15.

BEFORE RETURNING FOR REPAIRS

15.1 When a charging problem arises, make certain that the battery is capable of accepting a normal charge. Be sure to double check all connec-

tions, AC outlet for power, charger clips or ring terminals are clean and for proper polarity.

15.2 When a battery is very cold, partially charged or sulfated, it will not draw the full rated amperes from the charger. It is both dangerous and

damaging to a battery to force higher amperage into it than it can effectively use.

16.

WIRTHCO ENGINEERING, INC., MINNEAPOLIS, MN 55439 MAKES THIS LIMITED WARRANTY TO THE ORIGINAL PURCHASER AT RETAIL OF THIS PRODUCT. THIS

LIMITED WARRANTY IS NOT TRANSFERABLE.

WirthCo Engineering, Inc. has a limited warranty for this battery charger for ﬁ ve years from date of purchase at retail against defective material or

workmanship. If such should occur, the unit will be repaired or replaced at the option of the manufacturer. It is the obligation of the purchaser to

forward the unit together with proof of purchase, transportation and/or mailing charges prepaid to the manufacturer or its authorized representative.

•

This limited warranty is void if the product is misused, subjected to careless handling, or repaired by anyone other than the manufacturer or its

authorized representative.

•

The manufacturer makes no warranty other than this limited warranty and expressly excludes any implied warranty including any warranty for

consequential damages.

•

This is the only express limited warranty and the manufacturer neither assumes nor authorizes anyone to assume or make any other obligation

towards the product other than this express limited waranty. The manufacturer makes no warranty of merchantability or ﬁ tness for purpose of this

product and expressly excludes such from this limited warranty.

•

Some states do not allow the exclusion or limitation of incidental or consequential damages or length of implied warranty so the above limitations

or exclusions may not apply to you.

•

This warranty gives you speciﬁ c legal rights and you may also have other rights which vary from state to state.

IMPORTANT SAFETY INSTRUCTIONS • SAVE THESE INSTRUCTIONS

WIRTHCO ENGINEERING, INC. • MINNEAPOLIS, MN 55439

Reason/Solution

The settings may be wrong. Check the charger settings.

Have the battery checked.

Circuit breaker cycles when current draw is too high. Check for shorted cables or clips

and replace if necessary.

The battery may not want to accept a charge due to a run-down state. Allow charging

to continue until battery has a chance to recover sufﬁ ciently to take a charge. If more

than 20 minute, stop charging and have the battery checked.

Shut the charger off and correct the lead connections.

No problem, this is a normal condition.

Have charger checked by a qualiﬁ ed service technician.

Crank time varies with the amount of current drawn.. If cranking draws more than

the Engine Start Rate, crank time may be less than 3 seconds.

Wait 4 minutes of rest time before the next crank to allow the battery and charger

to cool down.

Check for poor connection at battery and frame.

Check power cord and extension cord for loose ﬁ tting plug.

Check for open fuse or circuit breaker supplying AC outlet.

The thermal protector may have tripped and needs a little longer to close. Make sure

the charger vents are not blocked. Wait and try again.

On a severely discharged battery, charge for 10 to 15 minutes in the highest manual

rate to help assist in cranking.

LIMITED WARRANTY

OWNER'S MANUAL (MODEL #20093)

2/10/55 AMP Battery Charger & Maintainer Instructions for 6 & 12 Volt Batteries

Read Instructions Carefully for Safe Operation

READ THE ENTIRE MANUAL BEFORE USING THIS PRODUCT.

FAILURE TO DO SO CAN RESULT IN SERIOUS INJURY OR DEATH.

WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE

GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE

THAT EACH TIME BEFORE USING THE CHARGER, READ THIS MANUAL AND FOLLOW

THE INSTRUCTIONS EXACTLY.

This manual will show how to use the charger safely and effectively. Please read, understand and follow these instructions and precautions carefully, as

this manual contains important safety and operating instructions. The safety messages used throughout this manual contain a signal word, a message

and an icon.

The signal word indicates the level of the hazard in a situation.

indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury to the operator or bystanders.

indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury to the operator or bystanders.

indicates a potentially hazardous situation which, if not avoided, could result in moderate or minor injury to the operator or bystanders.

indicates a potentially hazardous situation which, if not avoided, could result in damage to the equipment or vehicle or

property damage.

Safety messages in this manual contain two different type styles.

• Unnumbered type states the hazard

• Numbered type states how to avoid the hazard.

The icon gives a graphical description of the potential hazard.

Pursuant to California Proposition 65, this product contains chemicals known to the state of California to cause cancer and

birth defects or other reproductive harm.

IMPORTANT SAFETY INSTRUCTIONS

Risk of electric shock or ﬁ re.

1.1

Do not expose the charger to rain or snow.

1.2

Use only recommended attachments. Use of an attachment not recommended by WirthCo Engineering, Inc. may result in a risk of ﬁ re, electric

shock or injury to persons or damage to property.

1.3

To reduce the risk of damage to the electric plug or cord, pull by the plug rather than by the cord when disconnecting the charger.

1.4

An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in the risk of ﬁ re and electric

IMPORTANT SAFETY INSTRUCTIONS • SAVE THESE INSTRUCTIONS

WIRTHCO ENGINEERING, INC. • MINNEAPOLIS, MN 55439