Dot-Spot clarios eco 10 W Manual do operador - Página 13
Procurar online ou descarregar pdf Manual do operador para Iluminação paisagística Dot-Spot clarios eco 10 W. Dot-Spot clarios eco 10 W 15 páginas.
Imprimir página
Operation
LED lights are extremely energy efficient and, under normal operation, have a very long life. To
ensure the maximum life of the LED and to increase the energy efficiency, the following should be
considered:
■ The turning on and off of the luminary should be carried out by the input circuit of the power
supply.
■ The turning off of the luminary via the PWM signal should not occur permanently since in this
case the electronics unit of the luminary continues operating.
■ Even if the luminary is equipped with a thermal fuse that protects the luminary against thermal
damage, a permanent abnormal operation should be avoided.
■ The heat dissipation of the LED must not be hindered. Therefore, do not cover the spot.
■ Avoid operating the spot in case of direct solar radiation.
■ In automatic mode, control the spot via timer and / or twilight switch.
Maintenance, disposal
Care
■ Clean the spot with a damp cloth every now and then.
■ The luminaries are made of stainless V4A steel or black coated aluminum. However, depending
on the environmental conditions and the surfacing material, the metal parts may present the
so-called flash rust, but this does not constitute a defect. Flash rust can be removed easily with
appropriate stainless steel cleaners. Flash rust is particularly likely when the housing comes
into contact with ferrous particles (e.g. iron and grinding dust, ferrous plant fertilizers or the
like).
Illuminants
LED lights, under normal operation, have a very long life. Therefore, the replacement of the lamp is
not provided. In case of questions, see the Service chapter.
Disposal
At the end of the useful life, dispose of the spot and all accessories in accordance with the appli-
cable environmental regulations. Electrical waste must not be disposed of with domestic waste.
24
Malfunction, failure detection and elimination
Malfunction
Cause
PWM line not connected
to ground or dimmer (only for the
colored version)
PWM signal not present
M12 connector system non laid
out properly, wrong components
Spot does not work
Line leading to the power supply,
dimmer is interrupted
Supply voltage towards the pow-
er supply is interrupted
Power supply defective
Luminary is defective
Spot flashes, flickers or
switches off after a short
Power supply is overloaded
time of operation, the
power supply gets very hot
Operation at high housing tem-
The luminosity of the
peratures, the THERMOPROTECT
spot decreases during
system reduces the power until
operation or the spot
the spot switches off, in order to
does not work anymore
protect the LED
Warranty
These terms of warranty apply to the purchase and use of our products in the Federal Republic of
Germany. In other countries the warranty conditions will be those stipulated in the terms of sales
and shipment for the respective country or by law. The legal warranty rights are not affected by this
warranty. This warranty statement is our voluntary service as manufacturer.
All dot-spot products are 100% checked and tested before leaving the factory. However, the occur-
rence of occasional failures during operation may not be completely excluded.
In accordance with legal provisions, we grant a two-year warranty from the date of purchase (invoice
receipt). This warranty refers to the proper function of the dot-spot garden and object spots and
accessories under normal conditions of use.
The warranty does not cover any damages resulting from normal wear or mechanical destructions
by outside forces.
Correction
check by connecting
the PWM wire to ground
Check dimmer
(PWM signal generator)
Check components of
the M12 connector system
Check cable,
replace if necessary
Check input voltage
at the power supply
Replace power supply
Send in luminary
Use power supply with higher
power output
Operation of the spot at low
ambient temperatures or with
better air circulation
25