DAGE-MTI HR120 Manual do utilizador - Página 7

Procurar online ou descarregar pdf Manual do utilizador para Monitor DAGE-MTI HR120. DAGE-MTI HR120 13 páginas. Monochrome monitor

The

IMPEDIANCE

of a 75Ω termination when the video signal only goes to the

monitor, or when the monitor is the last video component

attached to the video line. When the video signal is looping

through the monitor, the switch must be set in the

and the last video component must be terminated into 75Ω.

The following four controls are factory set and should

not require further adjustment. If a problem occurs,

refer adjustment to a qualified service technician.

V-Linear

This adjustment controls the monitor's vertical linearity.

The linearity of the monitor allows for equal scanning of the

monitor from top to bottom. Misalignment of the vertical

linearity results in circles becoming oblong or elliptical.

V-Size

As the name suggests, this controls the vertical size of

the monitor's picture. The control should be set to allow the

total image to reside in the viewing portion of the screen.

Focus

The focus controls the sharpness of the picture. The

control should be set for maximum sharpness of the image.

Sub-Bright

This control works along with the front panel's

BRIGHTNESS

output picture. The control should be set to provide the

correct range to the front panel's

switch provides convenient selection

control to provide the correct brightness of the

BRIGHTNESS

position

control.