Dahle 20404 Manual de operação - Página 6

Procurar online ou descarregar pdf Manual de operação para Triturador de papel Dahle 20404. Dahle 20404 8 páginas. 20400 series intermediate office shredders 20500 series economy office shredders
Também para Dahle 20404: Manual de operação (4 páginas), Manual de operação (4 páginas)

Imprimir página

CHANGING THE SHRED BAG

When the Shred Bag (8) is full, the shredder will automatically shut down. The

electronics will cause the amber Warning LED Indicator to light. Changing the

Shred Bag is quick and easy if you follow these simple directions.

1. Turn shredder off

2. Open Door (10) using Door Pull (9) to expose Waste Bin (7) and

Shred Bag (8).

3. Pull the Waste Bin and full Shred Bag out of the shredder.

4. Dispose of full Shred Bag.

5. Install new Shred Bag in Waste Bin, draping end of Shred Bag over edge of

Waste Bin.

6. Push Waste Bin, with new Shred Bag installed, back into shredder.

7. Close Door.

8. Turn on shredder and continue shredding.

CARING FOR YOUR SHREDDER

Clean covers with a clean dry cloth. Do not use water or solvents. Make sure you

disconnect your shredder from its power source before cleaning.

Paper shredders, like all mechanical equipment, need proper maintenance to

ensure efficient operation. Periodic lubrication of the cutting blades is important to

offset the friction generated within the cutting head. Frequency of lubrication will

vary depending on the shred size and the amount of usage. A strip-cut shredder

receiving light use (1 – 2 hours per week) will require lubrication only

once or twice a month, while the same machine used 1 – 2 hours per day will

require lubrication weekly. A cross-cut shredder should be lubricated every 1/2

hour of shredding time to maintain maximum capacity and efficiency.

The procedure for lubricating your shredder is simple, and can be performed by

any operator. The oil is packaged in a squeeze bottle and is applied directly to the

cutting blades through the feed opening (3). Run a fine stream of lubricant

from one side of the feed opening to the other. Run the shredder in REVERSE for

a few seconds to help distribute the lubricant evenly. You can now continue

shredding as usual.

DAHLE Shredder Oil is the only lubricant you should use in your paper shredder.

It has been specially formulated so as not to leave any residue that could attract

dust and clog the shredding mechanism. You can order DAHLE Shredder Oil

(item # 740) from your local dealer.

Repairs on your paper shredder should only be performed by qualified

technicians. If you need service, contact your local dealer, or you can contact

DAHLE North America Customer Service between 8:30 am and 5:00 pm EST at

(800) 995-1379.

NOTE: SHREDDER WILL NOT OPERATE UNLESS DOOR IS COMPLETELY CLOSED