Electra APE.1S0.x&x Manual de instruções de instalação - Página 6
Procurar online ou descarregar pdf Manual de instruções de instalação para Sistema de intercomunicação Electra APE.1S0.x&x. Electra APE.1S0.x&x 6 páginas. Resident building intercom 1 family touch line evolution
Imprimir página4.4 programming the additional indoor terminals
Operator 1
Main outdoor panel
Operator 1 will hear [
panel. Afterwards proceed to Step 2.
ENTERING
programming mode
step 2
Press the apartment's key, as many times as it
is shown in the table below:
( for every key you press you hear: [
Operator 2
Indoor
terminal
step 3
The panel makes a [
EXITING
programming mode
We encourage you to program the additional indoor terminals at the head office. With the devices laid out on a table, one operator follows the same steps.
4.5 functions and adjustments
1. Check
anywhere within the installation, during the
call and the communication, that the power tension
between +14 V ⟷ GND is higher than 12,0 V.
2. Check
the functions of the indoor terminals and the outdoor
panels: call, communication, access, audio monitoring.
When calling from outside, all indoor terminals will ring, but
just the one you answer from can be used during the call.
If the installation contains just 1 indoor terminal, these steps are not necessary.
All indoor terminals leave the producer with address 1.
The main indoor terminal will nOT be programmed.
Operatorul 1 is programming from the main outdoor panel (address 1).
] in the outdoor
BEEEEEEEEP
] )
BEEP
Main
Additional 1 Additional 2 Additional 3
×2
×3
(twice)
(three times)
] for confirmation.
BEEP
You have succesfully programmed an indoor terminal.
Call to check!
Label the devices you program so you don't misplace them in the installation.
Steps
Press both keys
hold until Operator 1 is done programming*.
* You will hear the first [
the second [
] when the terminal has been programmed
BEEP
Hold the keys pressed until you hear
×4
(four times)
You will hear the second [
You can now release the keys!
The installation has been adjusted by the producer for audio
communication to suit standard functioning conditions.
how to adjust the volume of the indoor terminal:
When the
LED is Red, the terminal is silent.
By pressing the
key you change between
different volume levels (White LED).
After the verifications, leave the indoor terminal on Open Volume:
→ white LED on.
how to choose the terminal's ringtone:
1. Simultaneously press and hold keys:
2. Release the keys a few seconds after
3. Press
to switch between ringtones.
4. Press
to set the ringtone.
step 0
All LEDs are off.
step 1
at the same time and
] by touching the two keys and
BEEP
the second [
] !
BEEP
step 3
].
BEEP
!
begins flashing Red/White!
Operator 2
Additional terminal
ENTERING
programming mode
Keep holding the keys
pressed!
Red/White LED
during programming mode
EXITING
programming mode
page 6/6