Doug Fleenor Design NODE2-A Manual - Página 3
Procurar online ou descarregar pdf Manual para Equipamento de gravação Doug Fleenor Design NODE2-A. Doug Fleenor Design NODE2-A 10 páginas. Two port ethernet to dmx512 interface
Imprimir página
Jumper settings
Five configuration jumpers are located on the rear of N
installation. Jumper functions are described in the table below.
Jumper
JP1
Front panel displays turn off after 30
seconds of inactivity
JP2
Port A up/down buttons operate normally
JP3
Port B up/down buttons operate normally
JP4
Normal operation
JP5
Normal operation
Jumper settings are only read during power up. If a jumper position is changed, power must
be cycled for the change to take effect.
Mounting
N
2 can be mounted in many standard two-gang electrical boxes. A deep box (minimum
ODE
2.125 inches) is required for the electronics and to allow space for the network connection.
Raco model 683SP is an example of such a box.
Care must be taken to ensure that no part of the electronics are touching the box. Do NOT
attempt to install N
ODE
box will destroy a powered unit.
Powering
N
2 is powered using Power Over Ethernet (PoE). This simplifies installation by allowing the
ODE
installer to pull a single CAT5 (or higher) cable to N
Ethernet signals. A PoE switch or a PoE power injector must be used to provide power to
N
2. The diagrams below illustrate both methods of powering N
ODE
PoE Switch
PoE Injector
Installed function
2 while power is applied as even momentary electrical contact with the
Page 3 of 10
2. Jumpers should be set prior to
ODE
Removed function
Front panel displays are always on
Port A buttons are locked out
Port B buttons are locked out
Restore factory default settings
Force into boot loader mode
2. The cable provides power and
ODE
2.
ODE