Com-Power CGO Series Manual de instruções - Página 7
Procurar online ou descarregar pdf Manual de instruções para Gerador portátil Com-Power CGO Series. Com-Power CGO Series 11 páginas. Comb generators
Também para Com-Power CGO Series: Manual de instruções (14 páginas)
Imprimir página
Comb Generators model CGO‐520
Controls and indicators
Power on Switch
This is located on the side of the Comb Generator. It not only powers unit on or off, it also enables or disables the
signal output.
Output connector
The comb generator output is available at the SMA (f) connector located on the top of the unit. This output can be
used for radiated or conducted emissions testing. For radiated measurements, the monopole antenna is attached
to this connector. There are two antennas with SMA male connectors provided to cover the Comb Generator
radiated frequency range. Please refer to page 3 to determine the approximate frequency range of each antenna.
The antenna can be disconnected for conducted emissions measurements. Do not connect the Comb Generator
conducted output to a Line Impedance Stabilization Network (LISN) that is connected to AC power. We also do
not recommend connecting the Comb Generator conducted output directly to a preamplifier input.
Power On indicator
The green power on LED is lit, the Comb Generator is powered on and output is available for measurement.
Battery Low indicator
When red battery Low LED is lit, the internal battery needs recharging. The output may not be reliable. Turn off
Comb Generator and charge the battery with the supplied adapter. The approximate time to fully charge the
battery is 8 hours. The Comb Generator can operate approximately 18 hours when fully charged. Please note
however, that the operating time given in this manual is approximate and depends on the condition of battery,
storage period and the number times it has been charged and discharged. If the operating time keeps decreasing,
you may need to replace the battery.
(949) 459‐9600
www.com‐power.com
Page 7 of 11
Rev. 0216