Dahua HAC-HDBW2220EN Manual do utilizador - Página 11
Procurar online ou descarregar pdf Manual do utilizador para Câmara de segurança Dahua HAC-HDBW2220EN. Dahua HAC-HDBW2220EN 18 páginas. 1/2 megapixel 720p/1080p vandal-proof ir hdcvi dome cameras
Imprimir página
3 Installation
Important
Before the installation, please make sure the installation surface can sustain at least 3X weight
of the bracket and the camera.
3.1 HAC-HDBW2120EP/N and HAC-HDBW2220EP/N
The dome camera usually uses the ceiling installation. It can be installed on the ceiling or the wall.
For side exit cable installation, please make sure the side exit cable direction is the same as shown in
the installation position map.
Before you secure the screws on the pedestal, please put the cable through the cable exit of the
pedestal.
Before you complete the installation and debug, do not remove the electrostatic film. After you remove
the film, do not touch the enclosure in case there is any scratch.
Step 1
Take the installation position map from the accessories bag and then put it on the surface of the ceiling or
the wall according to the cable exit position. Dig three holes according to the installation position map and
then take three expansion bolts from the accessories bag and put them to the holes you just dug.
Step 2
Use inner hex wrench to remove the three enclosure fastening screws and then remove the dome
enclosure.
Step 3
Adjust the pedestal position according to the cable exit mode (ceiling/side). Pull the cable through the
cable side exit at the installation surface and the pedestal (Please skip this step if you want to use ceiling
exit mode). Line up the screw holes at the bottom of the pedestal to the expansion bolts in the installation
surface. Put three self-tapping screws to expansion bolts and then secure firmly. Now the pedestal is on
the installation surface.
Figure 3-1
5