Advance Tabco K-175 Instalação e funcionamento - Página 2

Procurar online ou descarregar pdf Instalação e funcionamento para Cozinha & amp; Acessórios de casa de banho Advance Tabco K-175. Advance Tabco K-175 2 páginas. Electronic faucet splash/deck mounted

Imprimir página

Parts List

1. Main Body

2. Spout

3. Infrared Sensor Eye

4. Splash Nut

5. Connect Line Cable

6. Filter

7. Control Box

8. Battery Cover

9. On/Off Control Button

10. Adapter: 100-240 VAC (Included)

11. Mechanical Mixing Valve

with Check Valves

12. Flexible Inlet Supply Lines

13. Flexible Supply Hose To Faucet

14. Elbow

Install as Shown

with Tab

Facing Down

Maximum Running Time: 60 Seconds

Response Time:

0.3 Seconds

Sensing Range:

1-7 Inches From Sensor

Power Source:

AC and/or DC

Low Battery Indicator:

Red LED On

Sensor Range Setup

1. Plug in the AC Power Adapter OR install Four (4) AA Alkaline

Batteries (See below for battery installation).

2. Sensor Range can only be set by using the on/off button situated

on the bottom right corner of the control box.

Do not attempt to open Control Box.

3. Push and hold the on/off button for 5-7 seconds (Figure 1).

Water will flow and then it will stop. Release button.

4. Place hand in front of the Electronic Eye and leave there until the

Red LED Light inside the Electronic Eye starts blinking.

5. Slowly, move your hand away from the sensor and stop at the

desired location you wish to have the faucet activate. Hold your

hand position until the LED Light blinks, signaling that the sensor

range is detected (figure 2).

With your other hand, Press the on/off button again to save the

new settings (Figure 1). The LED Light will stay on momentarily

indicating faucet is set.

Figure 1

Battery Installation

1. Your Sensor Faucet Requires Four (4) AA Alkaline Batteries. If the

AC Adapter is plugged in, unplug it from its power source.

2. Using a Philips Screw Driver, remove the cover's

three (3) screws and pull cover away from the

Control Box using pliers (Figure 3).

3. Remove old batteries if applicable.

4. Install the new AA Alkaline batteries, making

sure the "+" and "-" symbols are facing in the

correct directions. Place the cover back on the

Control Box and tighten screws.

Fresh Alkaline Batteries should last

approximately 400,000 on/off cycles.

Figure 2

Figure 3