Baumer GXMMW Manual - Página 7

Procurar online ou descarregar pdf Manual para Conversor de multimédia Baumer GXMMW. Baumer GXMMW 24 páginas. Absolute encoder with powerlink interface
Também para Baumer GXMMW: Manual (41 páginas), Manual (19 páginas), Manual (26 páginas), Manual (19 páginas)

Imprimir página

4. Commissioning

4.1. Mechanical mounting

Shaft encoders

• Mount the encoder by help of the mounting holes and three screws (square flange: 4 screws) provided at

the encoder flange. Observe thread diameter and depth.

• There is an alternative mounting option in any angular position by eccentric fixings, see under

accessories.

• Connect drive shaft and encoder shaft by using an appropriate coupling. The shaft ends must not touch

each other. The coupling must compensate temperature and mechanical tolerances. Observe the

maximum permitted axial or radial shaft load. For appropriate couplings please refer to accessories.

• Tighten the mounting screws firmly.

End shaft/hollow shaft encoders

• Mounting by clamping ring

Prior to mounting the encoder open the clamping ring completely. Push encoder onto the drive shaft and

tighten the clamping ring firmly.

• Adjusting element with rubber buffer

Push the encoder onto the drive shaft and insert the cylindrical pin into the adjusting element (customer-

mounted) and the rubber buffer.

• Mounting angle

Push the encoder onto the drive shaft. Insert adjusting angle into the encoder's rubber buffer and fasten

the mounting angle at the contact surface.

• Stud screw

Push the encoder onto the drive shaft and insert the stud screw (customer-mounted) into the encoder's

rubber buffer.

• Spring washer

Fasten the spring washer at the mounting holes of the encoder housing using screws. Push the encoder

onto the drive shaft and mount the spring washer to the contact surface.

4.2. Electrical connection

Ever store and transport the bus cover in the ESD bag only.

For electrical connection remove the bus cover as follows:

•

Release the fastening screws of the bus cover

•

Carefully loosen the bus cover and lift off in an axial direction

4.2.1.

Cabling

PROFINET utilizes Fast Ethernet cable (100MBit, Cat 5) composed of four wires AWG22 (white, yellow, blue

and orange).

There are three types of PROFINET cables:

•

Type A – for fix or rigid cabling

•

Type B – for occasional movements or vibrations (flexible)

•

Type C – for permanent movements (highly flexible).

Manual_PROFINET_EN.doc

17.10.11

7/24