DOUGHXPRESS DXA-SS Manual do Proprietário - Página 2

Procurar online ou descarregar pdf Manual do Proprietário para Equipamento comercial para alimentos DOUGHXPRESS DXA-SS. DOUGHXPRESS DXA-SS 16 páginas. Air driven automatic dough press

Imprimir página

1. Troubleshooting

RECEIVING & SETUP

PLEASE READ THIS MANUAL IN ITS ENTIRETY

INSPECTION

Inspect your box and machine for hidden shipping damage. Contact the delivery

company immediately, should you find damage.

PLATEN SURFACE

Slight surface imperfections are a normal part of the aluminum casting process for

the platens on your press. These are not considered a defect and do not affect the

functionality of the machine in any way.

SHIPPING OR RETURNS

NOTE: Save all of your shipping/packing materials.

DO NOT RISK COSTLY SHIPPING DAMAGE!

SHIP ONLY IN ORIGINAL BOX.

Fasten machine to plywood shipping base with bolts provided.

Make sure handle is pressed down so that the heat platen will not swing around

during shipment.

Place in original box, and put side liner and top liner in place. Fold in flaps and

seal the box.

*Additional bottom boards, box and liners may be obtained from your supplier

for a nominal cost.

INSTALLATION

Lift press from skid and place on cart, if you purchased one with the press.

Align legs with holes in top of cart and bolts (supplied) fasten to cart. You will

need a 9/16 wrench.

2. Remove plywood shipping base from press.

CAUTION:

Heavy lifting can cause injury. We recommend two person lifting

or use of a mechanical aid when handling this press. Remember

to always maintain natural curves of back and bend knees to lift.

Plug the cord of the press into a correctly grounded electrical outlet. The correct

voltage is indicated on the identification tag of the press.

WARNING: When using an extension cord, use 12 or 14 ga.-3 conductor.

Maximum length, 25' (7.62 m).

Remove wrap from handle and platens.

Supply a clean (void of oils) and dry (void of water) air source of 110-130 P.S.I.

(7-8 bar) to the 1/4" NPT air inlet located on the back panel of the machine.

Requires 1 CFM (30 L/min). It is strongly recommended that an external air filter

and water trap be installed at the machine's air inlet connection. This equipment

has small valves and ports that can become blocked from moisture and residue

in compressed air causing it to malfunction. Damages to the equipment's

internal air operated components resulting from unfiltered air are not covered

under warranty. Combination air filter/water traps are available at any major

hardware store or may be purchased directly from doughXpress (part #71145).

BEFORE OPERATING YOUR PIZZA PRESS.