Baumer Hubner Berlin HMG 11 Instruções de montagem e de utilização - Página 16

Procurar online ou descarregar pdf Instruções de montagem e de utilização para Conversor de multimédia Baumer Hubner Berlin HMG 11. Baumer Hubner Berlin HMG 11 40 páginas. Absolute encoder ethercat
Também para Baumer Hubner Berlin HMG 11: Manual de instruções de instalação e funcionamento (48 páginas), Manual de instruções de instalação e funcionamento (40 páginas), Instruções de montagem e de utilização (36 páginas)

MOUNTING / HOW TO PREVENT MEASUREMENT ERRORS

4.5

How to prevent measurement errors

To ensure that the device operates correctly, it is necessary to mount it accurately as de-

scribed in section 4�1 to 4�4, which includes correct mounting of the torque arm�

The radial runout of the drive shaft should not exceed 0�2 mm (0�03 mm recommended),

to prevent an angle error�

An angle error may be reduced by increasing the length of L1

L2 of the torque arm, see below, is at least equal to L1

The angle error Δρ

Δρ

= ±90°/π · R/L1

mech

with R: Radial runout in mm

L1:

Example of calculation:

For R = 0.06 mm and L1 = 69.5 mm the resulting angle error Δρ

For more information, call the telephone hotline at +49 (0)30 69003-111

For this different support plates for the torque arm are available on request�

If L2 < L1, L2 must be used in the calculation formula�

12/35

can be calculated as follows:

mech

Distance of the torque arm to the center point of the device in mm

MB244EN - 11171691, 19A2, Baumer_HMG10-SSI_II_EN

� Make sure that the length

�

equals ±0�025°�

mech