Douglas Dynamics SnowEx HDV 77775 Manual de instruções de instalação - Página 11
Procurar online ou descarregar pdf Manual de instruções de instalação para Acessórios para automóveis Douglas Dynamics SnowEx HDV 77775. Douglas Dynamics SnowEx HDV 77775 16 páginas. Snowplow
Imprimir páginaOPERATIONAL TEST AND FINAL ADJUSTMENTS
5. Adjust the position of the hose brackets so that
the hoses loop out and away from the center of
the T‑frame as shown in the photo below. Tighten
the 1/4" locknut to prevent the hose brackets from
turning.
Hose Wrap
6. Install the provided hose wrap as shown above
to prevent the hoses from chafing and premature
wear.
NOTE: Failure to complete the installation of
the hose brackets and hose wrap may result in
premature wear and damage to the hoses.
AeroShell
is a registered trademark (
®
Lit. No. 52592, Rev. 04
) of Shell Oil Company.
®
7.
Turn the control ON and raise and lower the
snowplow several times. With the plow in the
raised position, fully angle the snowplow from right
to left several times. Activate the control FLOAT
function and make sure the blade is lowered
completely to the ground. Turn the control OFF.
Do not mix different types of hydraulic fluid.
Some fluids are not compatible and may cause
performance problems and product damage.
8. Remove the filler plug and check the fluid
level. The fluid level should be 1"–1-1/2" below
the fill hole. If additional fluid is needed, add
SnowEx
Rapid Action Hydraulic Fluid rated
®
to –40°F (–40°C), or other fluid conforming to
Military Specification MIL-H-5606 A, such as
Mobil Aero HFA or Shell AeroShell
fluid is 1"–1-1/2" below the fill hole.
NOTE: Loosen the breather slowly to relieve any
pressure in the reservoir.
9. Replace and tighten the breather.
11
CAUTION
Fluid 4 until
®
July 15, 2020