Douglas Dynamics SnowEx HELIXX 3.5 yd3 Manual de instruções de instalação - Página 9
Procurar online ou descarregar pdf Manual de instruções de instalação para Espalhador Douglas Dynamics SnowEx HELIXX 3.5 yd3. Douglas Dynamics SnowEx HELIXX 3.5 yd3 19 páginas. Poly hopper spreaders
Imprimir página2. Carefully set the spinner drive assembly on the
ground.
3. Orient the spinner drive assembly in the operating
position, and then use two locking pins to attach
it to the chute supports. Install the top locking
pin first, as shown (second hole down in the
chute supports). Use a cotter pin to secure each
locking pin.
Chute
Supports
Locking
Pins
Spinner
Drive
Assembly
INSTALL MOUNTING HARDWARE
1. Position the spreader so the spinner drive
assembly is approximately 1" away from the rear
of the vehicle.
Lit. No. 74041, Rev. 00
MOUNTING THE SPREADER
Cotter
Pins
Mounting Hole
Locations
9
CAUTION
Before drilling holes, check to be sure that no
vehicle wiring or other components could be
damaged.
2. Using the mounting holes in the spreader fork
pockets as a template, mark the mounting hole
positions on the vehicle bed (see below), and drill
9/16" holes for the frame cap screws.
NOTE: Pay special attention when drilling or
clamping dissimilar metals to aluminum bodies.
Galvanic corrosion can occur if not handled
properly. Contact vehicle manufacturer for
recommended attachment practices.
3. Secure the spreader to the vehicle bed through
the fork pockets, using at least one fastener per
fork pocket. Use 1/2" hardware as required by the
vehicle application.
WARNING
Spreader shall be bolted to vehicle frame.
Do not rely on the tie-down chains or straps
alone to hold spreader in vehicle.
NOTE: If the mounting holes are not directly over
the vehicle box supports, the vehicle bed must
be braced to the frame to prevent buckling or
deforming the vehicle bed.
June 15, 2019