Douglas Dynamics WESTERN ENFORCER 94040-3 Manual de instruções de instalação - Página 11
Procurar online ou descarregar pdf Manual de instruções de instalação para Soprador de neve Douglas Dynamics WESTERN ENFORCER 94040-3. Douglas Dynamics WESTERN ENFORCER 94040-3 19 páginas. Ultramount 2 snowplow
Imprimir páginaOPERATIONAL TEST AND FINAL ADJUSTMENTS
HYDRAULIC UNIT
WARNING
Keep 8' clear of the blade when it is being
raised, lowered, or angled. Do not stand
between the vehicle and blade or directly in
front of the blade. If the blade hits or drops on
you, you could be seriously injured.
The ENFORCER™ snowplow hydraulic system comes
from the factory pre-assembled, partially filled, and
fully tested.
1. Position the lift frame in the upright position with
the stand supporting the snowplow.
2. Place the driver‑side lift chain over the cable boot
bracket on the side of the upper lift frame.
Clevis
Pin
Washer
Hairpin
Cotter
3. Remove and retain the two hairpin cotters,
washers, and pins attaching the lift arm to the
lift frame.
NOTE: Support the lift arm after removing the pins
to prevent it from falling forward.
4. Pivot the lift arm and lift ram forward and remove
the hydraulic unit cover.
Lit. No. 74914, Rev. 01
5. Remove and discard the factory‑installed pipe
Lift
Arm
Place
lift chain
NOTE: Do not replace the hydraulic unit cover at
here.
this time.
6. Pivot the lift arm and lift ram up. Replace the two
7.
8. Turn the control ON and completely retract the
11
plug from the top of the reservoir and install the
breather.
Breather
Pipe
Plug
Drain
Cap
pins, washers, and hairpin cotters to reattach the
lift arm to the lift frame.
Attach the snowplow to the vehicle according to
the instructions on the back of the blade.
WARNING
To prevent accidental movement of the blade,
always turn the control OFF whenever the
snowplow is not in use. The power indicator
light will turn OFF.
lift ram. Activate the control FLOAT function and
completely collapse the lift ram manually.
Fill
Plug
June 1, 2020