Douglas Dynamics 29070-1 Manual de Instruções - Página 5

Procurar online ou descarregar pdf Manual de Instruções para Equipamento de teste Douglas Dynamics 29070-1. Douglas Dynamics 29070-1 8 páginas. Isolation module tester

Imprimir página

SETUP

The Isolation Module tester comes with a transformer,

for plugging the tester into a 110V AC outlet, and a set

of red and black alligator clips, for powering the tester

from a 12V vehicle battery.

The supplied tester harness is used to connect the

tester to the isolation module.

1. Plug the transformer into a wall receptacle or

connect the alligator clips to the vehicle battery

terminals:

• Red clip to POS (+) battery terminal.

• Black clip to the NEG (–) battery terminal.

When disconnecting, remove the black alligator

clip first, then the red alligator clip.

Do not plug the green 2-pin connector into the

tester yet.

2. Connect the harness 26-pin connector to the top

of the tester, turning the 2 knobs to secure the

connector.

Lit. No. 41936, Rev. 00

3. If the isolation module to be tested is installed in a

vehicle, disconnect the harnesses from the A, B,

and C ports of the module.

4. Connect the 10-pin plugs of the tester harness,

labeled A, B, and C, to the corresponding ports on

the isolation module.

41000

August 15, 2015