Advanced ExGo Series Manual - Página 17
Procurar online ou descarregar pdf Manual para Painel de controlo Advanced ExGo Series. Advanced ExGo Series 20 páginas. Remote status indicators
Imprimir página3.5 Key-Switch Installation
E X T I N G U I S H A N T
R E L E A S E
R E L E A S E D
I M M I N E N T
T I M E R H E L D
A B O R T E D
F A U L T
D I S A B L E D
M O D E
A U T O +
M A N U A L O N L Y
M A N U A L
4 8 5 - I N
S U P P L Y
I N P U T S
C O N T R A S T
A D J U S T
Using a sharp knife, cut through the fascia label using the key-switch mounting hole as a template.
Insert the key-switch assembly through the hole and secure with the fixing nut. Before fully tightening, insert the
slide-in label with the required function description into the pocket in the fascia label.
Plug the connector into the respective connector on the card.
Key-Switch assemblies are available in both trapped and non-trapped versions.
The function / action of the key-switch is defined in the control panel. Refer to the control panel manual for
further details.
3.6 Adjusting the LCD Contrast / Address setting
Press the CONTRAST ADJUST button. This display will show the contrast adjust option.
[RSI Address Setup]
THIS ADDRESS: 1
www.advancedco.com
F I R E
Z O N E - 1
R e m o t e S t a t u s I n d i c a t o r
Z O N E - 2
Z O N E - 3
S Y S T E M F A U L T
U S B
4 8 5 - O U T
R U N P R O G
R E B O O T
S W I T C H
Use the buttons to adjust the contrast (viewing angle) darker
or lighter as required. The bar graph adjusts to show the contrast
setting.
Press the button to confirm the setting.
The display will then show the unit address.
Use the buttons to adjust the address as required.
Press the button to confirm the setting.
The display will then revert to the normal operating display.
SLIDE-IN LABEL
Key-Switch Assembly
Nut
PL1
PL3
PL2
PL2: KEY-SW
PL3: 2-Way Relay Card
PL1: Manual Trigger
17