Amphenol Wind-Lok Series Manual de instruções de instalação - Página 5

Procurar online ou descarregar pdf Manual de instruções de instalação para Cabos e conectores Amphenol Wind-Lok Series. Amphenol Wind-Lok Series 12 páginas.

Imprimir página
Step 2:
Contact crimping
Put the contact on the cut cable until it is completely close to the cable insulation (the contact well and the cable in-
sulation layer should not exceed 1.5mm), and check whether the cable is installed in the correct position through the
observation hole of the contact (in the observation hole.) To see the cable conductor, use the corresponding contact
crimping tool to crimp the contact (see Appendix 2 for the recommended crimping tool or use other tools). Be careful
not to press into the observation hole of the contact when crimping, as shown in Figure 2 below.
4
D
Step 3:
Connector assembly
As shown in Figure 3, first put the O-ring on the front insert (for easy identification, the color of the O-ring is
changed from the actual black to red), and then install the front insert into the plug/socket assembly.
C
B
Then, as shown in Figure 4, first put the gland, adapter, retaining ring and rear insert into the cable first, put the
crimped cable contact into the front insert and then sleeve the rear insert, and then put the retaining ring Clamp it
into the groove of the shell. (as shown in Figure 5, the color of the shell components is changed to yellow for easy
identification). In order to confirm that the retaining ring is completely stuck, pull the contact backward to confirm
whether the contact can be pulled out. Finally, tighten the adapter and glands respectively installed to complete the
assembly.
Note: Please refer to Appendix 3 for the tightening torque of adapter and glands; refer to Appendix 4 for adapter
A
tightening tools.
NOTES
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION AND
SUCH INFORMATION MAY NOT BE DISCLOSED TO OTHERS FOR
ANY PURPOSE OR USED FOR MANUFACTURING PURPOSES
WITHOUT WRITTEN PERMISSION FROM THE AMPHENOL CORP.
4
Contact
3
Observation hole
Figure 2
Figure 3
UNLESS OTHERWISE SPECIFIED
LINEAR DIMENSIONS ARE IN INCHES
TOLERANCES:
.XXXX =
.XXX =
.XX =
.X =
ANGLES =
Amphenol STANDARDS PER 9-3800
THIRD ANGLE PROJECTION
Next Assembly
3
Cable
2
APPROVALS
PREPARED BY:
LEAD/PRODUCT ENGINEER:
ENGINEERING MANAGER:
.0005
.010
PRODUCT GROUP:
.03
AIPG DIVISION:
.1
2
MATERIAL SPEC
2
REVISIONS
ZONE
REV.
DESCRIPTION
AMPHENOL CORPORATION
DATE
Amphenol Technology (Zhuhai) Co. Ltd.
No. 63 Xinghan Road, Sanzao Town, Jinwan, Zhuhai, P
1800/1/2
C&I
AIO
PROCESS SPEC
SIZE
CAGE CODE
C
SCALE: 2:1
REF:
1
DATE
DOCUMENT NUMBER
R
SHEET 1 OF
1
5