Dover DESTACO TC1-050-T-02 Manual de serviço - Página 12

Procurar online ou descarregar pdf Manual de serviço para Equipamento industrial Dover DESTACO TC1-050-T-02. Dover DESTACO TC1-050-T-02 16 páginas.

TC1

Service Manual

Electric Module O-Ring Seal Replacement

The O-Ring seal in the master electric module protects the electrical interface between the master and

tool plates. The seal needs to be checked periodically for any cuts, damage, or abrasion and must be

replaced if damaged.

the master module seal. Servicing or maintaining the tool changer without isolating it from pneumatic

and electric power sources may result in electric shock and personal injury. WHILE SERVICE OR

MAINTENANCE WORK SHOULD NEVER BE DONE WITH THE TOOL CHANGER CONNECTED TO

A POWER SOURCE, by way of example, electric shock may result where maintenance or service work

involves the use of metallic tools or other electrical conducting materials, particularly when addressing

the O-Rings.

2. A seal replacement kit (Part No. SLKT-480) is available, refer Table.3 on Page 8.

3. Carefully remove the O-Ring and any residual glue without damaging the module surface or O-Ring

grooves.

4. Add a small amount of glue to the seal groove of the master module being careful not to contaminate the

electrical interface.

5. Place the new O-Ring in the seal groove of the electrical interface of the master module and press until

it is fully seated (see Fig.11). Carefully remove any glue that squeezes out without contaminating the

electrical contacts. No lubrication is required.

Note: Electric module of tool plate does not contain an O-Ring seal.

THREAD LOCKER

Remove all pneumatic and electric power sources from the tool changer before servicing

TOOL PLATE

TOOL ELECTRICAL

MODULE

M3 FLAT HEAD SCREW

2.5mm HEX KEY WRENCH

Fig.10

TC1 TOOL CHANGER

Service Manual

0.9 Nm