Dover Hydro Connected Total Eclipse Manual de início rápido - Página 14
Procurar online ou descarregar pdf Manual de início rápido para Controlador Dover Hydro Connected Total Eclipse. Dover Hydro Connected Total Eclipse 17 páginas.
Imprimir página
programming (continued)
Set Default Weight
Here the default load weight for this formula can be input.
When a load runs, either the default load weight or the operator-entered
actual load weight for a specific load is recorded in the data log (for
Reports).
1) Move the selection box onto the SET DEFAULT WEIGHT menu item and
press the Enter key to launch the F## LOAD WEIGHT input screen.
2) Change the active digit by pressing the Up / Down Arrow keys. Move
the digit selection cursor with the Left / Right Arrow keys.
3) When the desired load size has been input, press the Enter key to save
the weight and return to F## <formula name> menu.
Set Count Pump
An installer should ALWAYS designate a Count Pump to indicate the end
of a wash cycle, overriding the default automatic selection of the highest
numbered product in a formula. (The traditional term "Count Pump" is still
used, even when dispensing products with an eductor dispenser.)
NOTE! Only when the last programmed amount for the Count Pump
product is dispensed, will the Count Pump feature end the wash cycle and
reset the formula! Therefore, the installer must ensure that at least one
amount is programmed for the Count Pump product AND that the last
programmed amount is dispensed! (Or the cycle will be recorded as an
"incomplete load" and the Load Count statistical data will be incorrect.)
1) Select SET COUNT PUMP and press Enter key. The F## COUNT PUMP
selection screen displays all products with at least one amount set.
2) Move the selection box to the Count Pump product, and press Enter
key to save the selection and return to the F## <formula name> screen.
Set End Time Offset (optional)
Setting an end time offset can be useful in some scenarios to make the
Hydro Connect reporting more accurate.
This value will offset the end time recorded in Hydro Connect for a given
formula in the event that there is an operation after the count pump runs,
like a long extract process for example.
1) Select SET END TIME OFFSET and press Enter key. The F## END
OFFSET adjustment screen will be displayed.
2) Adjust the offset time (0-20 minutes) using the Up / Down Arrow keys.
The two sets of double-arrow cursors indicate that all digits will increase
or decrease at the same time.
3) When the proper time is selected, press the Enter key to save the
selection and return to the F## <formula name> screen.
14
Set Default Weight
F01 PADS
PRODUCT SETTINGS
SET DEFAULT WEIGHT
SET COUNT PUMP
SET END TIME OFFSET
EDIT NAME
CLEAR FORMULA
F01 LOAD WEIGHT
000 LB
OK
EXIT
Set Count Pump
F01 PADS
PRODUCT SETTINGS
SET DEFAULT WEIGHT
SET COUNT PUMP
SET END TIME OFFSET
EDIT NAME
CLEAR FORMULA
F01 COUNT PUMP
P1 PRE-WASH
P2 DETERGENT
P4 BLEACH ALTERNAT
P5 SOUR-CONDITIONR
Set End Time Offset
F01 PADS
PRODUCT SETTINGS
SET DEFAULT WEIGHT
SET COUNT PUMP
SET END TIME OFFSET
EDIT NAME
CLEAR FORMULA
F01 END OFFSET
00 MIN
OK
EXIT