Caraudio-Systems C2-MK-CD Manual - Página 10
Procurar online ou descarregar pdf Manual para Acessórios para automóveis Caraudio-Systems C2-MK-CD. Caraudio-Systems C2-MK-CD 18 páginas. C.logic interface for bmw professional navigation systems without idrive
Imprimir página3.3.4. Radio module with round-pin connector WITH factory CD-changer
Disconnect the audio cable
from harness C3C-BMW701
and remove pins from female
and male 12pin connector.
Loosen the female round-pin connector from the radio
module. Loosen the female 10pin CD-changer connector
of vehicle harness of the female round-pin connector.
Pin the female pins of the audio cable of harness
C3C-BMW701into the female 10pin CD-changer connector
and connect the corresponding female pins of the vehicle
harness to the male pins of the audio cable of harness
C3C-BMW701. Make sure to isolate all connections.
Use following assignments:
Interface Audio-cable
10pinconnector
Red
White
Black
Connect female 10pin CD-changer connector into female round-pin connector and female
round-pin connector back to the radio module.
3.3.5. Radio module with round-pin connector WITHOUT factory CD-changer
Installation is analogue to system with factory CD-changer installed. Only there is no female
10pin connector on the vehicles harness. Shorten the female 12pin connector for two
chambers (after expelling all the pins). Obeying the above pin-configuration, pin the female
pins of the audio cable of harness C3C-BMW701 into the 10pin shortened female connector.
The male pins of the audio cable of harness C3C-BMW701 are not used and should be
isolated. Connect female round-pin connector to radio module. Connect the shortened
female10pin connector of harness C3C-BMW701 to the CD-changer port of the radio module
while making sure that the correct pins are used. Fasten the female 10pin connector in the
round-pin connector to avoid later disengagement.
Version 10.05.2012
Pin to female
Pin 2
Pin 1
Pin 6
CD-changer
Soundsystem
C2-MK-CD