Caraudio-Systems V5-NTG45-PNP Manual - Página 7
Procurar online ou descarregar pdf Manual para Recetor para automóvel Caraudio-Systems V5-NTG45-PNP. Caraudio-Systems V5-NTG45-PNP 17 páginas. Compatible with mercedes benz vehicles with comand online ntg4.5 navigation and audio20 ntg45 system with 4pin hsd lvds connector
Imprimir página
3. Installation
Switch off ignition and disconnect the vehicle's battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle is sleep-mode. In case the sleep-mode does not show
success, disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
Prior to wire and device installation we suggest to connect and test correct function of all
after-market and factory infotainment equipment!
The interface is installed on the backside of the head unit.
3.1.
Connecting interface-box and harnesses
Quadlock female
vehicle harness
1
3
1
Remove the female Quadlock connector of the vehicle harness from the rear of the
navigation computer.
2
Remove optical leads from the female Quadlock connector of the vehicle harness and
insert them into the female Quadlock connector of harness V5C-MBN45 at the same
position.
3
Connect female Quadlock connector of vehicle harness to the male Quadlock
connector of harness V5C-MBN45.
4
Connect female Quadlock connector of harness V5C-MBN45 to the male Quadlock
connector of the navigation computer
Version 03.06.2015
5
V5C-MBN45
harness
2
Quadlock male
on rear side
of navigation
6
Interface-box
V5C-M613
FRONT
V5C-UNI01
harness
4
V5-NTG45-PNP