AmpliVox SN3045A Manual de instruções - Página 5

Procurar online ou descarregar pdf Manual de instruções para Sistema de púlpito AmpliVox SN3045A. AmpliVox SN3045A 8 páginas. Patriot series lecterns

Imprimir página

INSTALL BATTERIES– Model S805A & SW805A

Battery Power

1. The amp uses 10 " D " size Alkaline batteries (not

included); or the optional rechargeable

AmpliVox NiCad Battery Pack (S-1465) and

(S1460) AC adapter, purchase separately (Fig 3).

2. The removable battery door on the back of the

amp is designed to stay closed until you need to

change the batteries. Slip a finger nail under it and

slide it out. (Fig 1)

3. Lift the battery holder out. The plastic dividers be-

tween the batteries help prevent battery

corrosion. (Fig 2)

4. Install 10 fresh Alkaline " D" size batteries. Be

sure to observe the polarity when putting batteries

in the battery compartment. The negative (flat)

ends go against the springs. (Fig 2) Carefully

replace battery holder. Batteries should look like

they are standing up

DO NOT MIX BATTERY TYPES OR

ATTEMPT TO RECHARGE ALKALINE

BATTERIES. EQUIPMENT DAMAGE,

SAFETY HAZARD OR FIRE COULD

RESULT.

Note: The battery holder cable comes from the

factory already plugged into the connector. If

it comes loose, push it in securely. (Turn the

plug over if it doesn't fit; it only fits one way.)

5. Slide door back into place.

6. If using the S-1465 NiCad Battery Pack (Fig 3),

replace battery holder with the battery pack. Insert

the battery pack plug into the connector where the

battery holder was plugged into. Plug AC Adapter/

Recharger power supply (S1460) into the "DC

IN" jack on front panel of the amp. Plug into a

working electrical outlet. Charge 24 hours for full

charge before using.

SPEAKERS

•

Looking inside of Lectern you will see the backside of the

speaker enclosure. Unwrap speaker wires and bring them to

the front of the amplifier. Plug them into the speaker jacks

marked "L - SPEAKER - R".

Fig 1

Fig 2

Fig 3

S-1465

S-1460