Comcater AGL7-4G Manual de instruções de instalação - Página 4

Procurar online ou descarregar pdf Manual de instruções de instalação para grelha Comcater AGL7-4G. Comcater AGL7-4G 6 páginas. Series 70 gas-heated charcoal-grill

Imprimir página

• The appliance functions at the nominal thermal power when

is fitted with the appropriate injectors for the gas used and

the gas pressure measured at the manifold pressure test point

is commissioned to the appropriate nominal value as

specified in Table T5 in Appendix.

Setting the manifold gas pressure (Fig. 2)

• Remove the front panel.

• Remove sealed bolt PP from the test point pressure and

connect the pressure gauge pipe.

• Switch on the appliance following the instructions for use

and commission the test point pressure value to the

appropriate nominal values as specified in Table T5 in

Appendix.

TROUBLESHOOTING GUIDE

The pilot burner is difficult or impossible to ignite

• Gas supply pressure low.

• Gas pipe or injector clogged.

• Gas tap faulty.

• Piezo igniter faulty.

• Ignition electrode (ignition spark gas should be 3 + 1/0 mm)

or cable faulty.

The pilot burner goes out during use

• Thermocouple faulty, insufficiently heated or incorrectly

connected to gas valve.

• Gas tap faulty.

The main burner is difficult or impossible to ignite

• Gas supply pressure low.

• Injectors clogged.

• Gas tap faulty.

REPLACEMENT OF SPARE PARTS

Before every intervention close the gas and water shut-off

valves upstream the appliance and disconnect the

electrical supply.

Never tamper with any of the sealed components.

After every intervention, check for gas leaks, if necessary.

Burners, Thermocouples, Ignition electrodes

• Remove the front panel, grids, lava stone, braziers and

replace the component.

Gas tap, Piezo igniter

• Remove the front panel and replace the component.

USE AND MAINTENANCE INSTRUCTIONS

WARNINGS

Do not store flammable materials in or near the appliance. Do

not spray aerosols in the vicinity of this appliance while it is

in operation.

Beware of the appliance's hot surfaces!

This appliance is designed for professional use and must only

be used by trained personnel. It is exclusively designed to

cook food. Any other use is considered improper.

If the appliance breaks down, close the gas shut-off valve

upstream of the appliance and call the technical assistance

service.

Repairs should only be carried out by authorised service

centres.

For service and spares parts, please contact Comcater 1800

810 161.

The manufacture declines any responsibility if these

obligations are not respected.

Read this manual carefully and keep in a safe place.

(CR0500420) 4/6

Before using the appliance, thoroughly clean all surfaces that

may come into contact with food.

USE

Lava stone

• The appliance is supplied with 2 packs of lava stone per

brazier.

Spread the contents of a single pack uniformly over the

brazier.

Never exceed the stated amount. The second pack is only to

be used to restore the original level of lava stone as it is

gradually consumed during use.

Fat drainage tray

• Fat that falls from the grill during cooking passes through

the brazier to be collected in a special tray.

• This tray should be periodically emptied and cleaned.

Use of the grill

The gas tap control knob is marked with the following

symbols:

●

Off

Pilot ignition

maximum cooking temperature

minimum cooking temperature

Turning on the burners (Fig. 3)

• Press the knob in and turn to the position

• Press the knob fully in and press the piezo igniter button to

light the pilot flame. Hold the knob pressed in for approx. 20

seconds, then release it. If the pilot flame goes out, repeat the

operation

Make sure the pilot burner is lit by checking the flame

through the inspection hole in front panel.

• Turn the knob to the desired cooking temperature.

Turning off the burners

• To switch off the main burner, turn knob to position

• To switch off the pilot burner, turn knob to position ●.

CARE AND MAINTENANCE

• Do not wash the appliance with jets of water.

• Before cleaning the appliance, disconnect from the electric

power supply (if connected).

• Clean stainless steel surfaces daily using water and non-

abrasive detergents. Rinse thoroughly and dry.

• Do not use steel wool pads or chlorine-based products.

• Do not use corrosive substances to clean the floor

underneath the appliance.

• If the appliance is to remain idle for a long period, close the

gas shut-off cock upstream of the appliance and clean

thoroughly.

• The appliance should be inspected and the gas exhaust pipe

cleaned by an authorised service engineer at least twice a

year.

For this purpose we recommend taking out a service contract.

SPARE PARTS LIST

• Main burner

• Brazier

• Pilot burner

• Thermocouple

• Ignition electrode

• Gas tap

• Piezo igniter

• Lava stone