1byone O00QH-0013 Manual de instruções - Página 5

Procurar online ou descarregar pdf Manual de instruções para Acessórios 1byone O00QH-0013. 1byone O00QH-0013 8 páginas.

To reset the push buttons, you need to cut off

the power supply for the receiver and push

button.

Remove the batteries from the push button and

receiver. Then re-insert the batteries after 30

seconds. You can now pair the wanted push

buttons.

5. Installation:

Receiver: The receiver can be mounted on a wall

or just put in a flat place.

To be mounted on a wall:

Select a suitable location for the doorbell, usually

close to your outside door.

Drill holes on the wall. Next push the wall plugs

into the drilled holes and then insert the screws

into the wall plugs. Finally, mount the receivers

with screw.

Push button: Install the push button by

double-sided adhesive or by screws:

a. By double-sided adhesive:

Select a suitable location for the push button,

- 07 -

usually close to your outside door.

Stick the push button to the wall using the

included double-sided adhesive.

b. By screws:

・Select a suitable location for the doorbell,

usually close to your outside door.

・Pierce the two pre-stamped holes (A) on the

inner side of the back cover with a pointed

object. Drill holes on the wall. Next push the

wall plugs into the drilled holes and screw the

back cover onto the wall with screws.

・Push the front cover onto the back cover and

making sure it is securely closed to ensure IP

protection.

- 08 -