Follett FZR5-PL Series Manual de instalação, operação e serviço - Página 11

Procurar online ou descarregar pdf Manual de instalação, operação e serviço para Congelador Follett FZR5-PL Series. Follett FZR5-PL Series 20 páginas. -30 c undercounter plasma freezer
Também para Follett FZR5-PL Series: Manual de instalação, operação e serviço (17 páginas), Manual de instalação, operação e serviço (20 páginas)

Service –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

To adjust for proper latch engagement

1. Loosen striker plate mounting screws (Fig. 11.1).

2. Move striker plate up or down as required and tighten screws.

3. Test operation of latch.

To adjust for proper gasket seal

1. Loosen striker depth adjustment screw (Fig. 11.2).

2. Adjust stop in or out and tighten screws.

3. Test operation of latch.

1. Remove existing gasket from mounting track.

2. Verify mounting track is free of any remaining gasket material.

3. Align new gasket with mounting track and press firmly in place.

4. Open and close door, checking for proper gasket seal without

pinching against freezer.

5. Adjust latch and or striker as necessary for proper door closure.

Follett's slide-out compressor tray allows technicians to partially slide the

condensing unit from the freezer back without cutting refrigerant lines.

1. Remove rear panel (Fig. 12.1).

2. Remove two bolts securing condensing unit to freezer base

(Fig. 12.2).

3. Carefully slide out condensing unit (Fig. 12.3).

Note: Do not put strain on the refrigerant lines.

Fig. 11

Fig. 12

FZR Undercounter Plasma Freezer