Amprobe AM-110 TRMS Manual do utilizador - Página 3

Procurar online ou descarregar pdf Manual do utilizador para Multímetro Amprobe AM-110 TRMS. Amprobe AM-110 TRMS 15 páginas.

WARNING

To reduce the risk of fire or electric shock, do not expose this product to rain or

moisture. To avoid electrical shock hazard, observe the proper safety precautions

when working with voltages above 60 VDC or 30 VAC rms. These voltage levels pose

a potential shock hazard to the user. Do not touch test lead tips or the circuit being

tested while power is applied to the circuit being measured. Keep your fingers behind

the finger guards of the test leads during measurement. Inspect test leads, connectors,

and probes for damaged insulation or exposed metal before using the instrument. If

any defects are found, replace them immediately. Do not measure any current that

exceeds the current rating of the protection fuse. Do not attempt a current

measurement to any circuit where the open circuit voltage is above the protection fuse

voltage rating. Suspected open circuit voltage should be checked with voltage

functions. Never attempt a voltage measurement with the test lead inserted into the

µA/mA or A input jack. Only replace the blown fuse with the proper rating as specified

in this manual.

CAUTION

Disconnect the test leads from the test points before changing functions. Always set

the instrument to the highest range and work downward for an unknown value when

using manual ranging mode.

INTERNATIONAL ELECTRICAL SYMBOLS

Caution ! Refer to the explanation in this Manual

Caution ! Risk of electric shock

Earth (Ground)

Double Insulation or Reinforced insulation

Fuse

AC--Alternating Current

DC--Direct Current

The instruments conform to CENELEC Low-voltage directive 73/23/EEC and

Electromagnetic compatibility directive 89/336/EEC