Cardale safelift Manual de instruções de instalação - Página 4
Procurar online ou descarregar pdf Manual de instruções de instalação para Abertura de porta de garagem Cardale safelift. Cardale safelift 6 páginas. Trackless door gear
Imprimir página
www.thegaragedoorcentre.co.uk
Remove the retaining pin from the Spring
Anchor Bush with assistance of spanner on
pulley (see fig. 4). You now have tension
on the door. Take out 2 transit screws and
spacer from each upper weather strip.
Open/close door through full travel to test
runner position. If necessary make final
adjustment to runners for correct operation.
With door open insert 5 screws per side
(No.8 × 1") down each side runner.
6
At this stage it is necessary to fit the lock.
Refer to separate instructions provided
with the lock pack for fitting procedure.
7
From the front of the door, ensure handle
is turned fully anti-clockwise. From inside
garage place plastic lock cam onto the
square lock spindle in orientation shown
in fig 5. Fit latch lever over lock cam as
shown and fix with self tapping screw and
large washer provided.
Washer
1
No 10 ×
/
2
Self Tapping
Screw
FIG 5
8
With the door slightly open take top
spring catch assembly and engage into
formed tag (see fig. 6). Align fixing holes
with those in top of door and insert self
tapping screws (No. 10 ×
With door closed, remove park pin to
release latch pin (see fig 7). Align spring
support/catch bracket centrally over latch
pin with lower face level with the
underside of the head timber (see fig. 7)
Insert two No. 12 × 1
use sideways adjustments on screw slots
to ensure correct alignment.
www.thegaragedoorcentre.co.uk
0800 525 442
Lock Cam
Lock Spindle
Latch Lever
1
/
") provided.
2
1
/
" Posi Screws and
2
0800 525 442
www.thegaragedoorcentre.co.uk
Loop size
not to
exceed
25mm
M4 × 8mm
screw
FIG 6
Take the shorter cable with single loop
from pack and hook looped end onto top
hook on latch lever.
Slide cable clamp over free end, route
cable through hole in latch pin and return
through clamp (see fig. 6). Note Loop size
not to exceed 25mm. Adjust length of
cable to ensure correct catch pin
engagement (see fig. 7). Tighten screw
in clamp on completion of adjustment.
No. 12 × 1
1
/
2
posi screw
Nominal 6mm
Engagement
Park Position
Pin
Cable
Clamp
FIG 7
www.thegaragedoorcentre.co.uk
With door slightly
open insert Self
tapping screws
Top spring catch
Formed tag
Latch pin
Cable clamp
Catch
Bracket
FRONT