Cardax Prox Plus 125 Nota de instalação - Página 4

Procurar online ou descarregar pdf Nota de instalação para Leitor de cartões Cardax Prox Plus 125. Cardax Prox Plus 125 13 páginas.

Mounting

The Prox Plus 125 reader is designed to be mounted on any solid flat surface including

metal surfaces.

The recommended mounting height for the Prox Plus 125 reader is 1100mm from floor

level to the centre of the reader unit. However this may vary in some countries and you

should check local regulations for variations to this height.

Drill a 20mm (

surface to a minimum depth of 40mm (1

Run the building cabling through the base and grommet.

Fit the base to the 20mm (

four fixing screws.

Fit the screw caps over each fixing screw. The screw caps prevent water from entering the

reader via the fixing holes. The caps must be installed for the Prox Plus 125 reader to

comply with the environmental specification.

Note: The Prox Plus 125 reader has been designed to metric specifications therefore

any imperial measurements provided are approximate only.

Note: The grommet through which the cables feed into the base of the Prox Plus 125

reader helps to keep the unit waterproof.

inch) diameter hole for the base extrusion through or into the mounting

Note: It is very important that the base of the reader is flush with and tight against

the mounting surface. If you are mounting the Prox Plus 125 reader on a

rough surface you should make the surface as smooth as possible under the

reader and up to 25mm (1 inch) around the reader.

inch).

inch) hole and secure it to the mounting surface using the

Part Number 3E1086 R2

September 2002