Comelit 1256 Manual técnico - Página 5

Procurar online ou descarregar pdf Manual técnico para Unidade de controlo Comelit 1256. Comelit 1256 8 páginas. Actuator relay module
Também para Comelit 1256: Manual técnico (16 páginas)

Imprimir página

1. Operation and Programming

Operation and Programming

Art. 1256 offers the following six functions, depending on the position of jumper JP1:

A) Call repetition function

JP1 as illustrated in Fig. 1

JP3

JP1

FIG. 1

The relay is operated by closing the C.NO. contact in response to a call from the switchboard, external unit or landing; this

happens only if the user code for which you wish to repeat the call is set using the DIP-switch (e.g. to activate lights, ringtones,

paging function, CCTV alarm contacts, etc.). On receipt of a call from the external unit or the landing, single closure of the relay

takes place. In response to a call from the switchboard, the relay closes twice. Intercom calls are not repeated. The actuator

relay module can also be used alone, if you want to close the C.NO. contact rather than repeat the call to an apartment when

JP1

the external unit calls the user code set on art. 1256. The relay closure time is set to approximately 2 sec. To set the user code

by means of a DIP-switch, see

B) Activation function on switchboard call pushbutton

JP3

JP1 as illustrated in Fig. 2

JP1

FIG. 2

JP1

For use only with systems not equipped with switchboard art. 1998/A. The relay is operated by closing the C.NO. contact in response

to a switchboard call from an entry phone or video entry phone (e.g. to activate the following independently, using a specific

command: lights, CCTV alarm contacts, driveway gates, entrances without external units or other devices). The relay closure time can

be programmed using a DIP-switch (see

JP1

C) External unit light function / Stair light function

JP1 as illustrated in Fig. 3

JP1

FIG. 3

The relay is operated by closing the C.NO. contact in response to a call from an external unit to any address, on internal

ignition from a video entry phone (e.g. to automatically activate lights, CCTV alarm contacts, etc.). The relay closure time can

JP1

be programmed using a DIP-switch (see

D) Secondary door lock release function (without external unit)

JP1

JP1 as illustrated in Fig. 4

JP1

FIG. 4

The relay is activated when the door lock release pushbutton is pressed, if the user code of the entry phone or video entry

phone from which the command is sent is within the range defined using DIP-switches - see

door lock release using the door lock release command for entrances without an external unit). The relay closure time is set to

approximately 2 sec.

JP1

JP3

JP2

"addressing

table".

table

A). The function can be used only when the system is free.

table

A).

JP1

table B

(e.g. to activate a second