AMS TMD2620 Manual de início rápido - Página 3

Procurar online ou descarregar pdf Manual de início rápido para Unidade de controlo AMS TMD2620. AMS TMD2620 5 páginas. Proximity sensor evaluation module
Também para AMS TMD2620: Manual do utilizador (13 páginas), Manual do utilizador (14 páginas)

Imprimir página

Out of the Box

Each TMD2620 Evaluation Kit comes with the following components:

•

Controller board v2.2-A

•

TMD2620 Daughterboard

•

USB Cable with A connector and mini B connector

•

Flash Drive with Application Software and Documents

Software Installation

Most PCs should have one or more Universal Serial Bus (USB) ports. Install the ams flash drive

into an unused USB port. Double-click the Setup.exe file on the flash drive, or click Start -> Run

and type E:setup.exe and press Enter. IMPORTANT: Use the appropriate drive letter in the above

command to install the software. Flash Drive will commonly be assigned the next available drive

letter for example C: hard drive D: CD-ROM E: flash drive

The Setup Wizard will open and guide you through the installation of the TMD2620 host software,

(Figures 2 through 8). To re-install, run the setup.exe program again. To remove the software from

your computer (Figure 9), select ams -> TMD2620 EVM -> Uninstall TMD2620 EVM or use the

Windows Control Panel.

Connect Hardware

Plug the TMD2620 Daughterboard into the Controller board. (Figure 1) Always use ESD procedures

when handling the EVM.

Using the enclosed USB cable, plug the mini-B connector into the EVM module. Using the other

end of the cable, plug the USB A-connector into a USB port on the computer.

Start the Application

To start the application select ams->TMD2620 EVM->TMD2620 EVM on the All Programs menu.

Figure 1 TMD2620 EVM Kit

page 3/5