AMS Controls XL200 Series Especificações - Página 4

Procurar online ou descarregar pdf Especificações para Controlador AMS Controls XL200 Series. AMS Controls XL200 Series 8 páginas. Bar code scanner specifications
Também para AMS Controls XL200 Series: Manual de substituição da bateria (5 páginas), Manual de substituição da bateria (8 páginas), Manual de substituição da bateria (8 páginas)

Sick IDM160-300S Corded Bar Code Scanner Setup

Note: The following setup procedure works only with the Sick IDM160 bar code scanner. For other bar

code scanners, please contact the manufacturer for proper setup procedures.

When a Sick IDM160 bar code scanner is connected to an XL200 series controller for the first time, the

scanner must be setup to properly communicate with the controller before it can be used for data entry.

Setup Procedure

1. Turn on the scanner. The scanner plays a musical tone, indicating it is on.

2. Verify that the Power Light on the solid Blue or Green.

3. Turn off the XL200 series controller, but leave the scanner turned on.

4. Scan the bar codes on the next pages in order (top to bottom). Do not proceed to the next bar

code until you hear a beep confirming the scanner has read the bar code.

5. Once the bar codes are read, the setup is complete and the scanner is ready for operation.

NOTE: This particular scanner does not have the capability of turning off the "RTS/CTS" (pin 7 and Pin 8)

signal as described on page 1 of this document, therefore, pin 7 and Pin 8 of the DB9 Connector MUST

be clipped or removed for proper operation of the scanner. See the troubleshooting section for more

details.