Electrolux # Manual de utilização e cuidados - Página 17

Imprimir página

Electrolux # Manual de utilização e cuidados

Getting Starte

BEFORESETTINGOVENCONTROLS

[]

Oven Vent Location

The oven is vented through

the back-

guard. When the oven is on, warm air is

released through the vent. This venting

is necessary for proper air circulation in

the oven and good baking results.

Oven Rack

Oven vent

Removing and Replacing Oven

Racks

ALWAYS ARRANGE OVEN

RACKS WHEN THE OVEN IS COOL

(PRIOR TO OPERATING THE

OVEN). Always use oven mitts when

using the oven.

To remove an oven rack, pull the

rack forward. Lift up the rack off the

oven rack slider. To replace an oven

rack, place the rack on the slider into

the 4 pinholes located at the 4 corners

of the rack.

installing Oven Rack Supports

ALWAYS INSTALL OVEN RACK SUPPORT BEFORE

TURNING ON THE OVEN (WHEN THE OVEN IS COOL).

To remove the oven rack supports

for a self-clean cycle,

pull up the support from the oven rack support brackets to

disengage supports from the oven. If the rack supports are not

removed, the self-clean cycle won't start. Always remove the

left side support first. To install oven rack supports

insert the

rack supports into the rack support brackets on the oven side

as shown.

Toremove

fro.,

shders

To place on

i Pull oven rack forward

and

sliders

lift it up of the oven rack

slider.

Removing Non-Sliding Oven Racks

Simply pull the rack and slightly tilt it upward when the rack hits its stop position.

Replacing Non-Sliding Oven Racks

Insert the rack into the oven rack supports by inserting the rack openings into the rack sup-

_orts. Be sure the rack is at the same position on each oven rack support on both sides.

to-o o o o o o o o.o_o o,,orr o o o o o o o "o_

i J

.....

,nserttheopenin0s

into the rack support

Always arrange the oven racks when the oven is cool (prior to operating the oven). Always use

oven mitts when using the oven.