Electrolux # Manual de utilização e cuidados - Página 19

Imprimir página

Electrolux # Manual de utilização e cuidados

Surface

elements

and drip bowls

Hake sure drip bowls are in place - Absence of

these bowls during cooking may subject wiring or

components underneath to damage.

Never immerse a surface element

in water.

Be sure the range is cool before removing surface

elements or drip bowls. Be careful not to bend terminal

ends when replacing surface elements after cleaning.

Surface elements can be unplugged and removed to make

cleaning the drip pans easier. The surface elements clean

themselves when they are turned on. Food spilled on a hot

element will burn off. Food spilled on a COOL element may

be cleaned with a damp cloth--any

remaining soil will burn

off the next time the element is used.

To remove the surface elements and drip bowls:

Liftthe edge ofthe drip bowl across from theterminal end.

Lift the surface element and drip bowl together j ust

enough to clear the cooktop.

While holding the drip bowl and surface element, gently

pull the terminal end out from the terminal

plug. If

equipped, DO NOT remove the hold down clip from the drip

bowl.

ffElement

Hold

Support

Down

Clip

iT equipped)

Allow Element

Support to rest

on drip pan

inside rim.

To replace drip bowls and surface elements

Slide the terminal end on the elementthrough

the opening

in the drip bowl (See Fig. 1).

Align the elementsupportto

reston the rim insidethe drip

bowl. If your drip bowl is equipped with a hold down clip,

align the element support opposite the terminal end with

the slot in the hold down clip, and snap into place.

Afterthe element is positioned in the drip bowl, line upthe

terminal end with the terminal plug as shown.

Hold the surface element and drip bowl together as level

as possible and firmly push the terminal end into the

terminal

plug. Make sure element terminal

is seated

properly into terminal plug. Make sure the surface element

is level to reduce the hazard of pans sliding off the

element.

Protective

liners--Do

not use aluminum foil to line

surface drip bowls, or reflector pans. Only use

aluminum foil as recommended in this manual.

Improper installation of these liners may result in risk

of electric shock, or fire.

• When lowering the lift-up range cooktop, grasp the

sides with finger-tips only. Be careful not to pinch

fingers. DO NOT drop or bend the range cooktop when

raising or lowering. This could damage the cooktop

surface.

Terminal End

Main top

Terminal

Plug

Fig. 1

Cleaning drip bowls

Wash in hot, soapy water or in the dishwasher. Rinse and

dry while still warm. Hard to remove, burned on soil can be

removed by soaking the drip bowls for about 20 minutes in

a lightly diluted liquid cleanser or a solution of ammonia and

water (1/2 cup ammonia to i gallon of water). A nylon

scrubber may be used after soaking. DO NOT use abrasive

cleaners or steel wool, as they will scratch the surface.

Always rinse with clean water and polish dry with a soft

cloth.

Fig. 2

To raise the cooktop for cleaning (some models):

Graspthesidesand

lift from the front (See Fig. 2). Lift-up

rods will support the top in a raised position. Only lift the

top far enough to allow the support rods to snap into place.

Clean underneath using a clean cloth and hot, soapy water

To lower the top, gently push back on each rod to release

the notched support. Hold the range top and slide the lift

rods down into the range frame.